[c-nsp] CFM Configuration

[Mohammad Khalil]

Greetings all
I am trying to configure CFM using simple topology with xconnect as L2VPN service.
CE1 - PE2 - PE3 - CE7

ethernet cfm ieee
ethernet cfm global
ethernet cfm traceroute cache
ethernet cfm alarm notification all
ethernet cfm domain SPCOR_DOMAIN level 7
 service EVC_SRVC evc EVC1
  mep mpid 170
  mip auto-create
!
ethernet evc EVC1
 oam protocol cfm domain SPCOR_DOMAIN

interface GigabitEthernet1
 no ip address
 negotiation auto
 no mop enabled
 no mop sysid
 service instance 10 ethernet EVC1
  encapsulation dot1q 17
  xconnect 10.1.100.3 17 encapsulation mpls
  cfm mep domain SPCOR_DOMAIN mpid 170

For local learning , am able to get the information.

PE2#show ethernet cfm maintenance-points local
Local MEPs:
--------------------------------------------------------------------------------
MPID Domain Name                                 Lvl   MacAddress     Type  CC
Ofld Domain Id                                   Dir   Port           Id
     MA Name                                           SrvcInst       Source
     EVC name
--------------------------------------------------------------------------------
170  SPCOR_DOMAIN                                7     001e.f636.e6bf XCON  I
No   SPCOR_DOMAIN                                Up    Gi1            N/A
     EVC_SRVC                                          10             Static
     EVC1

Total Local MEPs: 1

Local MIPs: None

But am not able to get any remote information.

PE2#show ethernet cfm maintenance-points remote
PE2#

PE2#ping ethernet mpid 170 domain SPCOR_DOMAIN service EVC_SRVC
% No RMEP entry found in for mpid 170 at domain SPCOR_DOMAIN service EVC_SRVC, evc EVC1.

Any lights would be appreciated.