A end: #show mpls l2transport vc 1337 detail Local interface: Gi0/23 up, line protocol up, Ethernet up Destination address: 10.2.11.8, VC ID: 1337, VC status: up Output interface: Vl101, imposed label stack {27 169} Preferred path: not configured Default path: active Next hop: xx.xx.xx.xx Create time: 00:06:07, last status change time: 00:05:34 Last label FSM state change time: 00:05:34 Last peer autosense occurred at: 00:05:34 Signaling protocol: LDP, peer 10.2.11.8:0 up Targeted Hello: 10.2.11.9(LDP Id) -> 10.2.11.8, LDP is UP Graceful restart: not configured and not enabled Non stop routing: not configured and not enabled Status TLV support (local/remote) : enabled/supported LDP route watch : enabled Label/status state machine : established, LruRru Last local dataplane status rcvd: No fault Last BFD dataplane status rcvd: Not sent Last BFD peer monitor status rcvd: No fault Last local AC circuit status rcvd: No fault Last local AC circuit status sent: No fault Last local PW i/f circ status rcvd: No fault Last local LDP TLV status sent: No fault Last remote LDP TLV status rcvd: No fault Last remote LDP ADJ status rcvd: No fault MPLS VC labels: local 170, remote 169 Group ID: local n/a, remote 0 MTU: local 1500, remote 1500 Remote interface description: Test: testing - 01 Sequencing: receive disabled, send disabled Control Word: Off (configured: autosense) Dataplane: SSM segment/switch IDs: 20487/4097 (used), PWID: 11 VC statistics: transit packet totals: receive 0, send 13 transit byte totals: receive 0, send 1664 transit packet drops: receive 0, seq error 0, send 0 B end: #show mpls l2transport vc 1337 detail Local interface: Gi0/23 up, line protocol up, Ethernet up Destination address: 10.2.11.9, VC ID: 1337, VC status: up Output interface: Vl101, imposed label stack {24081 170} Preferred path: not configured Default path: active Next hop: xx.xx.xx.xx Create time: 00:11:52, last status change time: 00:11:13 Last label FSM state change time: 00:11:13 Last peer autosense occurred at: 00:11:13 Signaling protocol: LDP, peer 10.2.11.9:0 up Targeted Hello: 10.2.11.8(LDP Id) -> 10.2.11.9, LDP is UP Graceful restart: not configured and not enabled Non stop routing: not configured and not enabled Status TLV support (local/remote) : enabled/supported LDP route watch : enabled Label/status state machine : established, LruRru Last local dataplane status rcvd: No fault Last BFD dataplane status rcvd: Not sent Last BFD peer monitor status rcvd: No fault Last local AC circuit status rcvd: No fault Last local AC circuit status sent: No fault Last local PW i/f circ status rcvd: No fault Last local LDP TLV status sent: No fault Last remote LDP TLV status rcvd: No fault Last remote LDP ADJ status rcvd: No fault MPLS VC labels: local 169, remote 170 Group ID: local n/a, remote 0 MTU: local 1500, remote 1500 Remote interface description: Test: testing - 01 Sequencing: receive disabled, send disabled Control Word: Off Dataplane: SSM segment/switch IDs: 16390/4097 (used), PWID: 11 VC statistics: transit packet totals: receive 0, send 24 transit byte totals: receive 0, send 3072 transit packet drops: receive 0, seq error 0, send 0 Switch A config: version 15.6 no service pad service timestamps debug datetime msec show-timezone service timestamps log datetime msec show-timezone service password-encryption service unsupported-transceiver platform bfd allow-svi ! clock summer-time BST recurring last Sun Mar 2:00 last Sun Oct 2:00 clock calendar-valid no ip source-route ip routing ! mpls label protocol ldp mpls traffic-eng tunnels mpls traffic-eng logging lsp path-errors mpls traffic-eng logging lsp reservation-errors mpls traffic-eng auto-tunnel backup mpls traffic-eng auto-tunnel backup timers removal unused 1800 1800 mpls traffic-eng auto-tunnel backup tunnel-num min 401 max 599 xconnect logging pseudowire status ! spanning-tree mode rapid-pvst spanning-tree extend system-id diagnostic bootup level minimal errdisable recovery cause udld errdisable recovery cause link-flap errdisable recovery cause storm-control ! transceiver type all monitoring vlan internal allocation policy ascending ! vlan 101 name ospf-pathA ! vlan 102 name ospf-pathB ! l2 router-id 10.2.11.9 ! interface Loopback0 ip address 10.2.11.9 255.255.255.255 ! ! interface GigabitEthernet0/23 description Test: testing - 01 no switchport no ip address xconnect 10.2.11.8 1337 encapsulation mpls ! interface GigabitEthernet0/24 description Test: testing - 02 no switchport no ip address xconnect 10.2.11.8 1338 encapsulation mpls ! interface TenGigabitEthernet0/1 description PathA switchport trunk allowed vlan 101 switchport mode trunk mtu 9212 ! interface TenGigabitEthernet0/2 description Path B switchport trunk allowed vlan 102 switchport mode trunk mtu 9212 ! interface Vlan101 description OSPF - PathA mtu 9000 ip address xx.xx.xx.xx 255.255.255.254 no ip redirects no ip proxy-arp ip ospf authentication null ip ospf network point-to-point ip ospf dead-interval 15 ip ospf hello-interval 5 ip ospf cost 100 ipv6 address xxx::xxx/126 ipv6 enable ipv6 nd ra suppress ipv6 ospf authentication null mpls ip mpls traffic-eng tunnels mpls traffic-eng administrative-weight 100 ipv6 ospf 1 area 0 ipv6 ospf network point-to-point ipv6 ospf hello-interval 5 ipv6 ospf dead-interval 15 ! interface Vlan102 description OSPF - PathB mtu 9000 ip address xx.xx.xx.xx. 255.255.255.254 no ip redirects no ip proxy-arp ip ospf authentication null ip ospf network point-to-point ip ospf dead-interval 15 ip ospf hello-interval 5 ip ospf cost 100 ipv6 address xxx::xxx/126 ipv6 enable ipv6 nd ra suppress ipv6 ospf authentication null mpls ip mpls traffic-eng tunnels mpls traffic-eng administrative-weight 100 ipv6 ospf 1 area 0 ipv6 ospf network point-to-point ipv6 ospf hello-interval 5 ipv6 ospf dead-interval 15 ! router ospf 1 router-id 10.2.11.9 no auto-cost area 0 authentication message-digest redistribute connected subnets redistribute static subnets passive-interface default no passive-interface Vlan101 no passive-interface Vlan102 network xx.xx.xx.xx 0.0.0.1 area 0 network xx.xx.xx.xx 0.0.0.1 area 0 mpls traffic-eng router-id Loopback0 mpls traffic-eng area 0 ! router bgp xxxxx bgp router-id 10.2.11.9 no bgp enforce-first-as bgp log-neighbor-changes no bgp default ipv4-unicast neighbor iBGP-vpls peer-group neighbor iBGP-vpls remote-as xxxxx neighbor iBGP-vpls update-source Loopback0 neighbor 10.2.11.8 remote-as xxxxx neighbor 10.2.11.8 peer-group iBGP-vpls ! address-family l2vpn vpls neighbor iBGP-vpls suppress-signaling-protocol ldp neighbor 10.2.11.8 activate exit-address-family ! ip forward-protocol nd ! ipv6 router ospf 1 router-id 10.2.11.9 no auto-cost passive-interface default no passive-interface Vlan101 no passive-interface Vlan102 redistribute connected redistribute static ! mpls ldp router-id Loopback0 Switch B config: version 15.6 no service pad service timestamps debug datetime msec show-timezone service timestamps log datetime msec show-timezone service password-encryption service unsupported-transceiver platform bfd allow-svi ! clock summer-time BST recurring last Sun Mar 2:00 last Sun Oct 2:00 clock calendar-valid no ip source-route ip routing ! mpls label protocol ldp mpls traffic-eng tunnels mpls traffic-eng logging lsp path-errors mpls traffic-eng logging lsp reservation-errors mpls traffic-eng auto-tunnel backup mpls traffic-eng auto-tunnel backup timers removal unused 1800 1800 mpls traffic-eng auto-tunnel backup tunnel-num min 401 max 599 xconnect logging pseudowire status ! spanning-tree mode rapid-pvst spanning-tree extend system-id diagnostic bootup level minimal errdisable recovery cause udld errdisable recovery cause link-flap errdisable recovery cause storm-control ! transceiver type all monitoring vlan internal allocation policy ascending ! vlan 101 name ospf-pathA ! vlan 102 name ospf-pathA ! l2 router-id 10.2.11.8 ! interface Loopback0 ip address 10.2.11.8 255.255.255.255 ! ! interface GigabitEthernet0/23 description Test: testing - 01 no switchport no ip address xconnect 10.2.11.9 1337 encapsulation mpls ! interface GigabitEthernet0/24 description Test: testing - 02 no switchport no ip address xconnect 10.2.11.9 1338 encapsulation mpls ! interface TenGigabitEthernet0/1 description PathA switchport trunk allowed vlan 101 switchport mode trunk mtu 9212 ! interface TenGigabitEthernet0/2 description PathB switchport trunk allowed vlan 102 switchport mode trunk mtu 9212 ! interface Vlan101 description OSPF - PathA mtu 9000 ip address xx.xx.xx.xx 255.255.255.254 no ip redirects no ip proxy-arp ip ospf authentication null ip ospf network point-to-point ip ospf dead-interval 15 ip ospf hello-interval 5 ip ospf cost 100 ipv6 address xxx::xxx/126 ipv6 enable ipv6 nd ra suppress ipv6 ospf authentication null mpls ip mpls traffic-eng tunnels mpls traffic-eng administrative-weight 100 ipv6 ospf 1 area 0 ipv6 ospf network point-to-point ipv6 ospf hello-interval 5 ipv6 ospf dead-interval 15 ! interface Vlan102 description OSPF - PathB mtu 9000 ip address xx.xx.xx.xx 255.255.255.254 no ip redirects no ip proxy-arp ip ospf authentication null ip ospf network point-to-point ip ospf dead-interval 15 ip ospf hello-interval 5 ip ospf cost 100 ipv6 address xxx::xxx/126 ipv6 enable ipv6 nd ra suppress ipv6 ospf authentication null mpls ip mpls traffic-eng tunnels mpls traffic-eng administrative-weight 100 ipv6 ospf 1 area 0 ipv6 ospf network point-to-point ipv6 ospf hello-interval 5 ipv6 ospf dead-interval 15 ! router ospf 1 router-id 10.2.11.8 no auto-cost area 0 authentication message-digest redistribute connected subnets redistribute static subnets passive-interface default no passive-interface Vlan101 no passive-interface Vlan102 network xx.xx.xx.xx 0.0.0.1 area 0 network xx.xx.xx.xx 0.0.0.1 area 0 mpls traffic-eng router-id Loopback0 mpls traffic-eng area 0 ! router bgp xxxxx bgp router-id 10.2.11.8 no bgp enforce-first-as bgp log-neighbor-changes no bgp default ipv4-unicast neighbor iBGP-vpls peer-group neighbor iBGP-vpls remote-as xxxxx neighbor iBGP-vpls update-source Loopback0 neighbor 10.2.11.9 remote-as xxxxx neighbor 10.2.11.9 peer-group iBGP-vpls ! address-family l2vpn vpls neighbor iBGP-vpls suppress-signaling-protocol ldp neighbor 10.2.11.9 activate exit-address-family ! ip forward-protocol nd ! ipv6 router ospf 1 no auto-cost passive-interface default no passive-interface Vlan101 no passive-interface Vlan102 redistribute connected redistribute static ! ! mpls ldp router-id Loopback0