[cisco-voip] Cisco TCL IVR authentication ignore on outbound calls..

[Kyle Stone]

Here's the function...


proc act_Authenticated { } {
    global param
    infotag set leg_suppress_outgoing_auto_acct 1
    set ani_uniq  [infotag get leg_ani]
    set status [infotag get evt_status]
    set roaming [infotag get aaa_roaming $ani_uniq]

    aaa accounting start leg_incoming -s spectoracct

    if { ($status == "au_000") || ($roaming == "match") } {
        set dnis_uniq 5555555555
        set did  [infotag get leg_isdid]
        set dnislen [string len $dnis_uniq ]

        leg proceeding leg_incoming
        leg connect leg_incoming
        leg setup $dnis_uniq callInfo leg_incoming
        fsm setstate  PLACECALL

    } else {
        set dnis_uniq 8888888888
        set did  [infotag get leg_isdid]
        set dnislen [string len $dnis_uniq ]

       #infotag set cfg_avpair authentication disable
       #That didn't work.. it's read only.
        puts "TCL: failed auth"
        leg proceeding leg_incoming
        leg connect leg_incoming
        leg setup $dnis_uniq callInfo leg_incoming
        fsm setstate  PLACECALL
    }
}

Basically, it calls one number if it authenticates and another if it fails.

The problem is that, when it fails..  I get this from
"debug voip ivr callsetup"

*Dec  8 17:09:32.243: Destination SetupPeer cid(593499), 
destPat(8888888888), match(0), prefix(), peer(63EAA418)
*Dec  8 17:09:32.243: //-1//PCM :HN88B47DDC:/DNSettlementMatrixCheck: 
retcode=2 cid(593499) trans=0x0, provider=0 User is not authenticated 
and not roaming
*Dec  8 17:09:32.243: //-1//PCM :HN88B47DDC:/DNInitiate: 
DestinationSetupPeer Failed.



So can anyone tell me how to short circuit the Settlement Matrix Check, 
or hardwire up the roaming/authenticated valued?


Kyle Stone