[cisco-voip] 7200 VXB-2TE1 h323 gateway...

[Jeff Behl]

thanks.  one q remaining:  once I do this will i have the ability to 
add individual ports on the adaptor (there are two) to different route 
groups?


thanks again.
jeff

Wes Sisk wrote:

> Sounds like you have your route pattern directly at the gateway
> so the gateway is not eligible to be in a routegroup.
> To get around it consider something like this:
> 
> change your route patter to point at a route list
> (this frees the gateway to be added to a route group)
> 
> Then configure your gateway to be in the route groups you desire.
> 
> /Wes
> 
> 
>>-----Original Message-----
>>From: cisco-voip-bounces at puck.nether.net
>>[mailto:cisco-voip-bounces at puck.nether.net]On Behalf Of Jeff Behl
>>Sent: Monday, July 14, 2003 1:25 PM
>>To: cisco-voip at puck.nether.net
>>Subject: [cisco-voip] 7200 VXB-2TE1 h323 gateway...
>>
>>
>>i have a 7200 with the above which is currently registered to the cm. 
>>what i'd like to do is put each pri port into its own route group then 
>>create a route list of the two groups.  is this possible in this 
>>situation?  right now putting the gateway by itself into a route group 
>>isn't possible as it doesn't show up as a possible addtion when creating 
>>one, though I've heard that it won't show up if the gateway is already 
>>defined for use in a dial pattern...
>>
>>thanks
>>
>>_______________________________________________
>>cisco-voip mailing list
>>cisco-voip at puck.nether.net
>>http://puck.nether.net/mailman/listinfo/cisco-voip