[cisco-voip] dialing PRI v-gw

[Wes Sisk]

Scott,

Can you double check the featureimplementation with Berbee?  The way Berbee
explained it to me, they use a CTI PORT to initiate a call to any off-net
destination and then either stream the audio there, or use the CTI port to
place the call on hold and use the multicast hold stream.

/Wes

> -----Original Message-----
> From: cisco-voip-bounces at puck.nether.net
> [mailto:cisco-voip-bounces at puck.nether.net]On Behalf Of Voll, Scott
> Sent: Monday, April 19, 2004 3:32 PM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] dialing PRI v-gw
>
>
> I'm hoping that someone can give me a hand.
>
> We have purchased Berbee's InformaCast for IP Phone Paging and would
> like to also cross connect it with our PBX.
>
> Topology looks like this:
>
> Berbee
> CM    ---------- V-GW 2621 with HDV PRI ---------- PBX ------------PSTN
> Unity                       IOS 12.2.11T(9)
>
>
> Berbee is designed to do this via a FXO or FXS port.  The Twist is that
> I want to use a PRI and an Extension across it.  Any idea's how I would
> set something like this up?  On an FXO port you can assign a DN.  The
> PRI doesn't look quite the same.  Any ideas?
>
> Prerequisite is that the V-GW must be Multicast MoH.  Which my V-GW is,
> but the GW needs to be an endpoint and make the call to the extension on
> the PBX.
>
> TIA
>
> Scott
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip