[cisco-voip] CMM Blade

[J A Pine]

Speaking of 6608's, we purchased an additional WS-X66508-T1 blade for our
6509, which brings it up to 4 total.  Anyways, I've never experienced this
much difficulty in my life getting CM to register the new Gateways.  I have
all 8 ports set to DHCP, and they have no problems grabbing IP addresses and
gateway/tftp IP's.  The problem is occuring when I created the Gateway in
CM.  I am creating a PRI T1 Gateway.  The gateway never registers, and when
I view the port status on the switch, it reads "(Failed to obtain port
interface information)" when trying to display the IP address for the port.
I've enabled logging and reset the module, but do not see any errors.  As
soon as I delete the Gateway from CM, the port grabs an IP instantly.

Anyways, I read on CCO that there is a utility called "Dick Tracy" that you
can use to debug DHCP problems with 6608 modules.  I've found the commands,
but cannot locate the utility.  Is this utility something that can be
downloaded from Cisco.com, or do you have to get it from TAC?  I currently
have a case open with TAC, but need a solution quick.  If anyone has the
utility, could you send it to me off list?  Thanks in advance!

Jesse

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Walenta, Phil
Sent: Thursday, April 22, 2004 1:00 PM
To: Carter, Bill; Voll, Scott; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] CMM Blade

Don't get one yet.  Several horrible defects still exist in these.  I just
had to pull 12 off an install and replace with 6608's.

________________________________

From: cisco-voip-bounces at puck.nether.net on behalf of Carter, Bill
Sent: Thu 4/22/2004 11:14 AM
To: Voll, Scott; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] CMM Blade



I will be installing one next month.  I will report back.

Thanks,
Bill Carter

Sentinel Technologies, Inc.
Cisco Systems Global IP Communications
Partner of the Year
bcarter at sentinel.com
217-391-7015 (IP Phone)
217-415-5513 (M)

-----Original Message-----
From: Voll, Scott [mailto:Scott.Voll at wesd.org]
Sent: Wednesday, April 21, 2004 9:18 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] CMM Blade

Is anyone using one of these:

http://www.cisco.com/en/US/customer/products/hw/modules/ps3115/products_
data_sheet09186a00800e9c1f.html

We would like to purchase one this summer and would like to get some
feedback from someone who is using one in production.

TIA

Scott


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip



_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip