[cisco-voip] How to Block Caller-ID on 2600/5300 with T1/E1

[Arnd Vehling]

Hi,

Jared Mauch wrote:
> On Tue, Aug 17, 2004 at 12:10:36PM +0200, Arnd Vehling wrote:
>>does anyone know how to block the caller-id transmission
>>per default for all outgoing calls over an T1 Interface
>>on a cisco 2600/5300?
> 
> interface Serial1/0:23
>  no ip address
>  no logging event link-status
>  isdn switch-type primary-dms100
>  isdn incoming-voice voice
>  isdn calling-number xxx
> 
> 	you should just be able to set xxx to the number zero.
> 
> 	this will change what you send..

thx for the tip. It was easier than i thought. Setting

"isdn calling-number -"

did the trick :)

thx & best regards,

    Arnd