[cisco-voip] my c5350 disconnect immediately after connected?

[zhao xiaojing]

my c5350 connect to PSTN using E&M signaling, when i dial from pstn to my destination, the connection is closed immediately after connected.
the following is debug information.



1w1d: from Trunk(1): (1/2): Rx LOOP_CLOSURE (ABCD=1111)
1w1d: VDEV_ALLOCATE: 3/104 is allocated
1w1d:  1.starting digit collect: reset dnis_collected & fap_notify
1w1d: CSM_RX_CAS_EVENT_FROM_NEAT:(cid00AD): EVENT_CALL_DIAL_IN at slot 3 and port 104
1w1d: CSM_PROC_IDLE: CSM_EVENT_START_DIGIT_COLLECT at slot 3, port 104
1w1d: CSM DSPLIB(3/104/csm_flags=0x95): np_dsplib_prepare_modem
1w1d: csm_connect_pri_vdev: TS allocated at bp_stream 1, bp_Ch 84, vdev_common 0x62D55798 3/104
1w1d: to NEAT:(cid00AD) EVENT_CHANNEL_LOCK for slot1 ctlr1 chan2
1w1d: CSM DSPLIB(3/104):DSPLIB_SIG_INIT: Signaling session transition to IDLE
1w1d: CSM DSPLIB(3/104):DSPLIB_SIG_WAIT_ACTIVE: Signaling session transition to ACTIVE
1w1d: CSM DSPLIB(3/104): Modem went offhook
1w1d: CSM_PROC_IC1_COLLECT_ADDR_INFO: CSM_EVENT_MODEM_OFFHOOK (DNIS=, ANI=) at slot 3, port 104
1w1d: from Trunk(1): (1/2): Tx LOOP_CLOSURE (ABCD=1111)
1w1d: CSM_RX_CAS_EVENT_FROM_NEAT:(00AD):  EVENT_START_RX_TONE at slot 3 and port 104
1w1d: from Trunk(1): (1/2): Tx LOOP_OPEN (ABCD=0000)
1w1d: CSM DSPLIB(3/104/dnis=9727290000/ani=): np_dsplib_ani_dnis_collected
1w1d: CSM_PROC_IC1_COLLECT_ADDR_INFO: CSM_EVENT_ADDR_INFO_COLLECTED (DNIS=9727290000, ANI=) at slot 3, port 104
1w1d:  csm_call_info->dnis_collected is 1
1w1d: csm_check_accept_voice_call : controller=1, bchan=2 calling_party= called_party=9727290000 
1w1d:  cas_group=0, service=2
1w1d: csm_res_response: service_type=2, fax_call=0, fap_notify=0
1w1d: CSM_PROC_IC3_WAIT_FOR_RES_RESP: CSM_EVENT_RESOURCE_OK at slot 3, port 104
1w1d: csm_proc_ic3_wait_for_res_resp (3/104) Switching to voice
1w1d: csm_install_voice_vdev_vector_common(3/104): vtsp_cdb  0x0
1w1d: np_dsplib_voice_change_service (3/104)
1w1d: vtsp_ic_notify(3/104): voice_vdev 0x62B3CAC4, vtsp_cdb 0x0
1w1d:  vtsp_ic_notify calling 0ct3 0x0, called oct3 0x0, oct3a 0x0,mask 0x0
1w1d:  vtsp_ic_notify calling 0ct3 0x81, called oct3 0x81, oct3a 0x0,mask 0x0
1w1d: csm_vtsp_call_setup_resp_np (vdev_info=0x62B3CAC4, vtsp_cdb=0x63E7972C)
1w1d: csm_vtsp_call_setup_resp_np:vdev_common BP TS allocatedat bp_stream1, bp_Ch84
1w1d: CSM Voice(3/104): Call Proceeding (vtsp_cdb=0x63E7972C, vdev_info=0x62B3CAC4)
1w1d: CSM DSPLIB(3/104):DSPLIB_VOICE_INIT: Signaling session transition to FLUSHING
1w1d: CSM DSPLIB(3/104):DSPLIB_VOICE_INIT: Signaling session transition to IDLE
1w1d: from Trunk(1): (1/2): Tx LOOP_CLOSURE (ABCD=1111)
1w1d: VOICE DSPLIB(3/104):DSPLIB_VOICE_INIT: Voice session transition to IDLE
1w1d: np_voice_process_voice_service_changed (3/104)
1w1d: from Trunk(1): (1/2): Tx LOOP_OPEN (ABCD=0000)
1w1d: from Trunk(1): (1/2): Rx LOOP_OPEN (ABCD=0000)
1w1d: CSM_RX_CAS_EVENT_FROM_NEAT:(00AD):  EVENT_CALL_IDLE at slot 3 port 104 cause 200
1w1d: CSM_IC5_WAIT_FOR_SWITCH_OVER: CSM_EVENT_DSX0_DISCONNECTED at slot 3, port 104
1w1d: np_voice_call_hangup (3/104)
1w1d: CSM(3/104): Enter csm_enter_idle_state
1w1d: csm_vtsp_call_disconnect_np : (cdb=0x63E7972C)
1w1d: csm_vtsp_call_disconnect_np NULL voice_vdev from VTSP, cdb 0x63E7972C
1w1d: vdev_deallocate (3/104) Switching to back modem
1w1d: VDEV_DEALLOCATE: slot 3 and port 104 is deallocated
1w1d: VOICE DSPLIB(3/104):DSPLIB_IDLE: Voice session transition to ACTIVE
1w1d: VOICE DSPLIB(3/104):DSPLIB_IDLE: Voice session transition to FLUSHING
1w1d: VOICE DSPLIB(3/104):DSPLIB_IDLE: Voice session transition to IDLE
1w1d: CSM DSPLIB(3/104):DSPLIB_IDLE: Modem session transition to IDLE
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20041201/7e345b4e/attachment.html