[cisco-voip] International calling

[Candace Holman]

On an analog line  first thing to check is whether the route list or 
pattern is set up to send all the digits (Num Digits).  It may be sending a 
truncated set.  If its a T1 check the Called Party IE number type unknown 
and Called Numbering plan, number of digits to strip, etc.

Candace

At 04:25 PM 12/2/2004, you wrote:
>I'm using CM 3.3.4sr2 and a V-GW to call international calls.  Can
>anyone tell me why I get the error tones and, "You have called a number
>that has been disconnected or is no longer in service, please check the
>number and try again."  If I dial the number from my Cell it works but
>not from our VoIP system.
>
>I have tickets open with both the telco(qwest) and Cisco TAC, but have
>not gotten anywhere.  Since I'm getting that message that would mean I'm
>getting it from the telco, right?  When I hang up I get the normal call
>clearing in my debug isdn q931.
>
>Any ideas would be a help.
>
>TIA
>
>Scott
>
>????????????????????????????????????????????????????????????????????
>
>_______________________________________________
>cisco-voip mailing list
>cisco-voip at puck.nether.net
>https://puck.nether.net/mailman/listinfo/cisco-voip