[cisco-voip] International calling

[Voll, Scott]

This is a 5ess PRI running NI2 signalling.  Currently everything is set
to CM.  With this I get the error message stated in the first email.
This is running MGCP.  ISDN and International gets me busy signals.

Scott

Cat6K#
*Mar  1 15:39:21.747: ISDN Se3/2:23 Q931: TX -> SETUP pd = 8  callref =
0x0001
        Bearer Capability i = 0x8090A2
                Standard = CCITT
                Transer Capability = Speech
                Transfer Mode = Circuit
                Transfer Rate = 64 kbit/s
        Channel ID i = 0xA98397
                Exclusive, Channel 23
        Display i = 'Scott Voll'
        Calling Party Number i = 0x0081, '4571'
                Plan:Unknown, Type:Unknown
        Called Party Number i = 0x80, '011524552412811'
                Plan:Unknown, Type:Unknown
*Mar  1 15:39:21.799: ISDN Se3/2:23 Q931: RX <- CALL_PROC pd = 8
callref = 0x8001
        Channel ID i = 0xA98397
                Exclusive, Channel 23
Cat6K#
*Mar  1 15:39:23.439: ISDN Se3/2:23 Q931: RX <- PROGRESS pd = 8  callref
= 0x8001
        Cause i = 0x8381 - Unallocated/unassigned number
        Progress Ind i = 0x8288 - In-band info or appropriate now
available
Cat6K#
*Mar  1 15:39:35.812: ISDN Se3/2:23 Q931: TX -> DISCONNECT pd = 8
callref = 0x0001
        Cause i = 0x8090 - Normal call clearing

-----Original Message-----
From: Eric Knudson [mailto:ericknudson at gmail.com] 
Sent: Thursday, December 02, 2004 1:30 PM
To: Voll, Scott
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] International calling

One problem that I see commonly that seems to match this is when
you're using a 4ESS PRI, but aren't setting the plan/type to
international on the outgoing SETUP. Can you verify switchtype and
post q931 debugs?


On Thu, 2 Dec 2004 13:25:15 -0800, Voll, Scott <scott.voll at wesd.org>
wrote:
> I'm using CM 3.3.4sr2 and a V-GW to call international calls.  Can
> anyone tell me why I get the error tones and, "You have called a
number
> that has been disconnected or is no longer in service, please check
the
> number and try again."  If I dial the number from my Cell it works but
> not from our VoIP system.
> 
> I have tickets open with both the telco(qwest) and Cisco TAC, but have
> not gotten anywhere.  Since I'm getting that message that would mean
I'm
> getting it from the telco, right?  When I hang up I get the normal
call
> clearing in my debug isdn q931.
> 
> Any ideas would be a help.
> 
> TIA
> 
> Scott
> 
> ????????????????????????????????????????????????????????????????????
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>


This message was scanned for viruses by BitDefender.
For more information please visit our web site
http://www.bitdefender.com/

????????????????????????????????????????????????????????????????????