[cisco-voip] new gateway setup

[Wes Sisk]

Hi Chad,

I your carrier does not like your called party number:

58426804

5 - access code?
842 - local exchange
6804 - extensoin

I suspect you will want to drop the 5 as well.  You can do this either in CM (95.XXXXXXX) with predot discard.  Or you can do this on the router with dial-peers or translation-rule.  

/Wes



Chad Whitten wrote:

>im trying to get a new gateway setup - its a 2610xm with a pri vwic.  ive got 
>it configured for mgcp and my callmanager has it registered.  i setup a new 
>route pattern - 5.@ to point all calls to this gateway, but when i dial 
>5-nxx-XXXX, im seeing the 5 being passed along with the number which shouldnt 
>be happening.  
>
>when i created the route pattern, i just took my standard 9.@, copied it, 
>change the 9 to a 5 and changed the selected gateway.
>
>from a debug isdn q931
>2w4d: ISDN Se1/0:23 Q931: TX -> SETUP pd = 8  callref = 0x0002
>        Bearer Capability i = 0x8090A2
>                Standard = CCITT
>                Transer Capability = Speech
>                Transfer Mode = Circuit
>                Transfer Rate = 64 kbit/s
>        Channel ID i = 0xA98397
>                Exclusive, Channel 23
>        Display i = 'Chad Whitten'
>        Calling Party Number i = 0x0080, '6019880998'
>                Plan:Unknown, Type:Unknown
>        Called Party Number i = 0xA1, '58426804'
>                Plan:ISDN, Type:National
>2w4d: ISDN Se1/0:23 Q931: RX <- RELEASE_COMP pd = 8  callref = 0x8002
>        Cause i = 0x829C - Invalid number format (incomplete number)
>  
>