[cisco-voip] new gateway setup

[Chad Whitten]

this might be a dumb question, but how many dial-peers do i need on my 
gateway?

im used to using h323 and having two dial peers - one voip with a destination 
pattern of 9T that points to my callmanager, one pots that points to my pstn 
interface.

like this:
dial-peer voice 1 pots
 destination-pattern 9T
 progress_ind alert enable 8
 direct-inward-dial
 port 1/0:23
!
dial-peer voice 101 voip
 preference 1
 incoming called-number .
 destination-pattern ....
 progress_ind setup enable 3
 voice-class codec 1
 voice-class h323 1
 session target ipv4:172.16.0.5
 dtmf-relay h245-alphanumeric
 fax-relay ecm disable
 fax rate disable
 ip qos dscp cs5 media
 no vad


On Tuesday 07 December 2004 10:12, you wrote:
> Hi Chad,
>
> I your carrier does not like your called party number:
>
> 58426804
>
> 5 - access code?
> 842 - local exchange
> 6804 - extensoin
>
> I suspect you will want to drop the 5 as well.  You can do this either in
> CM (95.XXXXXXX) with predot discard.  Or you can do this on the router with
> dial-peers or translation-rule.
>
> /Wes
>
> Chad Whitten wrote:
> >im trying to get a new gateway setup - its a 2610xm with a pri vwic.  ive
> > got it configured for mgcp and my callmanager has it registered.  i setup
> > a new route pattern - 5.@ to point all calls to this gateway, but when i
> > dial 5-nxx-XXXX, im seeing the 5 being passed along with the number which
> > shouldnt be happening.
> >
> >when i created the route pattern, i just took my standard 9.@, copied it,
> >change the 9 to a 5 and changed the selected gateway.
> >
> >from a debug isdn q931
> >2w4d: ISDN Se1/0:23 Q931: TX -> SETUP pd = 8  callref = 0x0002
> >        Bearer Capability i = 0x8090A2
> >                Standard = CCITT
> >                Transer Capability = Speech
> >                Transfer Mode = Circuit
> >                Transfer Rate = 64 kbit/s
> >        Channel ID i = 0xA98397
> >                Exclusive, Channel 23
> >        Display i = 'Chad Whitten'
> >        Calling Party Number i = 0x0080, '6019880998'
> >                Plan:Unknown, Type:Unknown
> >        Called Party Number i = 0xA1, '58426804'
> >                Plan:ISDN, Type:National
> >2w4d: ISDN Se1/0:23 Q931: RX <- RELEASE_COMP pd = 8  callref = 0x8002
> >        Cause i = 0x829C - Invalid number format (incomplete number)

-- 
Chad Whitten
Network Administrator
neXband Communications
cwhitten at nexband.com
601-944-4801 Phone
601-944-4803 Fax