[cisco-voip] VoIP to VoIP calls

[kostas anagnopoulos]

Hi,

Do you have any sample config regarding transcoding in ip-to-ip gw.I cannot
find anything relevant on cco.

thanks,
Kostas

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net]On Behalf Of Steven E. Ames
Sent: Friday, December 10, 2004 4:11 PM
To: shafiim at global-telecom.com; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] VoIP to VoIP calls


This has been sorta possible with H.323 to H.323 legs for a while. A recent
release 12.3.11(T) allows SIP<->H.323. The key is here:

voice service voip
 allow-connections sip to h323

Would allow an incoming SIP call to match to an outgoing H.323 dial-peer.
Codec transcoding is also possible (but only g.711/g.729).

-Steve

> -----Original Message-----
> From: cisco-voip-bounces at puck.nether.net
> [mailto:cisco-voip-bounces at puck.nether.net]On Behalf Of
> Shafii MOHAMMED
> Sent: Friday, December 10, 2004 6:48 AM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] VoIP to VoIP calls
>
>
> Hi,
> I was wondering if voice enabled routers like 2600, 3600, or
> 5300 support
> voip to voip dial-peers.
>
> I have defined two dial-peers on my 2651XM like this:
>
> !
> dial-peer voice 1 voip
>  destination-pattern .T
>  session target ipv4:10.1.1.1
> !
> dial-peer voice 2 voip
>  destination-pattern 1000
>  session target ipv4:10.1.1.2
> !
>
> I am trying to let my 2651XM route a call from one voip dial
> leg to another
> voip dial leg, is this possible?
>
> Thanks,
> Shafii
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip

--
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.




-- 
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.