[cisco-voip] CMM

[Voll, Scott]

On the switch I put in:

config t  
interface gigabit 9/1  
no shutdown  
switchport  
end  
write memory

As described in the link.

Then session slot 9 proc 0

Then setup an IP address on interface G1/0

Setup both 
Ip route 0.0.0.0 0.0.0.0 10.10.10.1
& 
Ip default-gateway 10.10.10.1

I can ping anything in the 10.10.10.x subnet, but nothing outside the
local subnet.  Is this an IOS issue on the Sup/msfc?  Or what did I
miss?

TIA

Scott

-----Original Message-----
From: Walenta, Phil [mailto:philip.walenta at berbee.com] 
Sent: Thursday, July 22, 2004 8:06 AM
To: Voll, Scott; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] CMM

You need to configure two things.
 
1.  The switch IOS must be properly set up and trunked to the CMM.
 
2.  CMM interface must have proper addressing.
 
Usually most folks don't have the trunk set up correctly.
 
 
Here's the link with full details:
 
http://www.cisco.com/univercd/cc/td/doc/product/lan/cat6000/cfgnotes/78_
14107.htm

________________________________

From: cisco-voip-bounces at puck.nether.net on behalf of Voll, Scott
Sent: Thu 7/22/2004 9:45 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] CMM



I have a CMM blade from the Demo Depot and I can't get it to route
outside of its own subnet.  What I'm I doing wrong? 

Interface G9/1
Ip address 10.10.10.5

IP route 0.0.0.0 0.0.0.0 10.10.10.1

Sup1a/msfc2 running native IOS 12.1.19e

TIA

Scott


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip