[cisco-voip] SEPDefault.cnf

[Wes Sisk]

This is a binary file that isn't very intuitive.  It does contain the
"default loads" aka, which loads all endpoints should run unless a
device-specific load is configured.  Get a friend with CM(E) to configure
the defaults you need, then copy of the generated file.

If you don't mind my asking, what SCCP server are you planning to use other
than CM or CME?

/Wes

> -----Original Message-----
> From: cisco-voip-bounces at puck.nether.net
> [mailto:cisco-voip-bounces at puck.nether.net]On Behalf Of TC
> Giufre-Sweetser
> Sent: Saturday, June 19, 2004 6:15 PM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] SEPDefault.cnf
>
>
>
>
> How do you generate this file if you dont use CM or CME?
>
>
> ---
> Terence C. Giufre-Sweetser
>
> +--------------------------------+--------------------------+
> | TereDonn Computer Engineering  |    FAX +61-[0]7-34204971 |
> |   PO BOX 485, MT GRAVATT 4122  | Mobile +61-[0]414-663053 |
> |          Queensland Australia  |  http://www.tdce.com.au  |
> +--------------------------------+--------------------------+
> | DSL from 256K to 16M, Qld wide coverage, Wholesale prices |
> +-----------------------------------------------------------+
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip