[cisco-voip] FXO dial in

[Walenta, Phil]

If it's h.323, it sounds like there isn't a dial peer pointing to a proper CallManager DN.
 
If it's MGCP, you may not have an MGCPapp defined for the port properly.

________________________________

From: cisco-voip-bounces at puck.nether.net on behalf of Jared Mauch
Sent: Fri 10/22/2004 10:57 AM
To: Voll, Scott
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] FXO dial in



On Fri, Oct 22, 2004 at 08:56:47AM -0700, Voll, Scott wrote:
> OK-
>
> It's been along time since I setup an FXO port.  I have a 1760 with two
> fxo ports.  I got it registered with CM 3.3.4sr2 and I can make calls
> out.  But when I call the number it rings then picks up and gives me
> dial tone.  I have set the GW to attendant DN 8000 but that doesn't seem
> to do anything.

voice-port x/y/z
        connection plar 8000

        - jared

>
> Can anyone give me any pointers?
>
> Thanks
>
> Scott
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip

--
Jared Mauch  | pgp key available via finger from jared at puck.nether.net
clue++;      | http://puck.nether.net/~jared/  My statements are only mine.
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip