RE: 答复: [cisco-voip] 答复: how to config the callmanager as a h323 gatekeeper

[Wes Sisk]

Hi Vincent,

In that case, Here is the admin guide for 3.1:
http://www.cisco.com/en/US/customer/products/sw/voicesw/ps556/products_admin
istration_guide_book09186a00800c2e23.html

/Wes

-----Original Message-----
From: vincent [mailto:vincent at net-2com.com]
Sent: Thursday, April 14, 2005 9:31 PM
To: 'Wes Sisk'; cisco-voip at puck.nether.net
Subject: 答复: [cisco-voip] 答复: how to config the callmanager as a h323
gatekeeper


Thank you for your reply,but My cm version is 3.1,not 4.1. So I found the
GK's configuration is not same as the guide which you give me !Thank you

-----邮件原件-----
发件人: Wes Sisk [mailto:wsisk at cisco.com]
发送时间: 2005年4月14日 21:08
收件人: vincent; cisco-voip at puck.nether.net
主题: RE: [cisco-voip] 答复: how to config the callmanager as a h323
gatekeeper

Vincent,

CM cannot perform as a gatekeeper.  If you need call admission control
native to callmanager, investigate the locations feature.

CM can however register to a gatekeeper to send and receive calls.  Just
configure the gatekeeper in CCMAdmin:

http://www.cisco.com/en/US/customer/products/sw/voicesw/ps556/products_admin
istration_guide_chapter09186a00803ed6e7.html

/Wes
-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net]On Behalf Of vincent
Sent: Thursday, April 14, 2005 2:13 AM
To: 'vincent'; cisco-voip at puck.nether.net
Subject: [cisco-voip] 答复: how to config the callmanager as a h323
gatekeeper


and also I have ever try to config the CM as a gateway to register to
another h323 Gatekeeper ,unluck,failed again. Can you give me a resolution?




发件人: vincent [mailto:vincent at net-2com.com]
发送时间: 2005年4月14日 13:44
收件人: 'cisco-voip at puck.nether.net'
主题: how to config the callmanager as a h323 gatekeeper


hi:
  I configed a gateway in the call manager3.1,and then I used a h323 gateway
to regist with the h323-id same as the gateway name which I configed in CM,
but I found the CM's 1719 port is unreachable, the GRQ was always timeout.
Anybody can help me ? Thank you very much