[cisco-voip] When I'm configuring the p2p t1

[Mark Snow]

It all depends on the type of WIC/VWIC card that you are using ....
What part number are you using?

If it is something like a WIC-2T then no, you will not (though you can still
do a 'sh controllers s0/0/0') - if it is something like a VWIC-1T1 then yes,
you will have a controller interface in which you make the T1 anything you
want (CAS, PRI, Channel-Group).

-Mark Snow
CCIE Voice #14073

> -----Original Message-----
> From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-
> bounces at puck.nether.net] On Behalf Of James
> Sent: Thursday, December 22, 2005 12:01 PM
> To: CiscosupportUpuck
> Subject: [cisco-voip] When I'm configuring the p2p t1
> 
> On confuring my p2p t1 for the remote srst site, I have my serial int but
no
> controller int. Isint this how it suppose to be
> James D. Grace
> System Engineer
> CCNP CCNA MCSE MCDBA
> Digitel Corp.
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip