[cisco-voip] Call rings phones once and then drops

[Wes Sisk]

CallManager Locations out of bandwidth causes this message, amoung  
other things.  Check the CCM traces... (or next hop address off the  
destination dial peer)

/Wes
On Dec 17, 2005, at 3:19 PM, TechGuy wrote:

Here is the debug:

emb3845#debug isdn q931
debug isdn q931 is              ON.
emb3845#
*Dec 17 20:07:23.806: ISDN Se0/1/1:23 Q931: RX <- SETUP pd = 8   
callref = 0x00D2
         Bearer Capability i = 0x8090A2
                 Standard = CCITT
                 Transer Capability = Speech
                 Transfer Mode = Circuit
                 Transfer Rate = 64 kbit/s
         Channel ID i = 0xA98381
                 Exclusive, Channel 1
         Calling Party Number i = 0x2183, '3375015555'
                 Plan:ISDN, Type:National
         Called Party Number i = 0x80, '4080'
                 Plan:Unknown, Type:Unknown
*Dec 17 20:07:24.830: ISDN Se0/1/1:23 Q931: TX -> RELEASE_COMP pd =  
8  callref = 0x80D2
         Cause i = 0x80A9 - Temporary failure
emb3845#


More info on the problem.  This router has two local PRI trunks  
coming in to a 2MFT card.  It also has two CAS (E&M Wink) trunks  
coming into a 2MFT card for long distance and incoming toll free.

The two CAS trunks work fine.  We are able to get incoming calls via  
the CAS trunks mentioned above with no problems.  Also, we have  
another gateway configured on the same callmanager in a similiar  
fashion and all works fine.  This was all working earlier this  
morning.  No known changes occured between when it worked and stopped  
working.

Quite an interesting problem, we have TAC on the line now but thought  
I would see what others think.
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip