[cisco-voip] Problems with CallerID on a PRI connected to
PA-VXC-2TE1
peter.casanave at us.army.mil
peter.casanave at us.army.mil
Tue Feb 8 14:02:07 EST 2005
This link may be of assistance:
http://www.cisco.com/en/US/customer/tech/tk652/tk653/technologies_configuration_example09186a00800a9a49.shtml
V/R,
PETER CASANAVE
SFC, USA
BBN Platoon Sergeant
----- Original Message -----
From: John Lange <john.lange at open-it.ca>
Date: Tuesday, February 8, 2005 12:27 pm
Subject: Re: [cisco-voip] Problems with CallerID on a PRI connected to PA-VXC-2TE1
> Thanks Dave.
>
> Unfortunately we tried that setting but it had no effect.
>
> Its very confusing to me how the Name information could be passing
> properly but not the number info.
>
> If you have any other suggestions I'd be glad to hear them.
>
> Thanks.
>
> John
>
>
> On Mon, 2005-02-07 at 12:22, Dave Temkin wrote:
> > Try:
> >
> > isdn outgoing display-ie
> > on your serial interface for the PRI
> >
> >
> >
> > -Dave
> >
> > On Mon, 7 Feb 2005, John Lange wrote:
> >
> > > We have an Asterisk Phone system that places outbound calls
> using SIP
> > > via a Cisco PA-VXC-2TE1+ card connected to an Allstream PRI.
> > >
> > > Try as we might we can not get callerid number working on outbound
> > > calls.
> > >
> > > Strangely, CallerID name display works perfectly fine.
> > >
> > > Allstream insists that their equipment is configured correctly
> and that
> > > they will accept the name/number we set on calls.
> > >
> > > So the question is, what is the setting on the Cisco so that
> it passes
> > > CID name and number?
> > >
> > > The following is the trace provided by Allstream on a sample
> outbound> > call from our equipment. As you can see DSP is set
> properly to the name
> > > but there is no CGN portion. (From my conversations with them my
> > > understanding is the CGN is the number, DSP is the name?)
> > >
> > > Below this trace is the current configuration for the Cisco.
> > >
> > > Any suggestions are welcome.
> > >
> > > Thanks.
> > >
> > > --------------
> > >
> > > <== 03:12:51:05.11 (CM Time: 02:15:56:55.12).
> > > <== Q931: SETUP: from S[7040] L[1,186,0] E[26,185,0] SPA[--
> --]
> > > CR: 0,01 6C
> > > BC: speech
> > > 64 kbit/s
> > > circuit mode
> > > mu-law speech
> > > CID: 18
> > > LENGTH: 03
> > > Channel Selection Info: As Indicated in Following Octets
> > > D-Channel Indicator: D-Channel NOT indicated
> > > Preferred/Exclusive: Exclusive
> > > Interface type = primary rate
> > > Interface Identifier: IID Implicitly Identified
> > > Channel Type: B - Channel Units (3).
> > > Number Map: Channel is indicated by the number following.
> > > Coding Standard: CCITT
> > > Channel Number = 23
> > > DSP: ±OpenIT
> > > CDN: unknown
> > > unknown
> > > 14162045956
> > > --------------
> > >
> > >
> > > Current configuration : 3012 bytes
> > > !
> > > ! Last configuration change at 14:10:36 CST Thu Feb 3 2005
> > > ! NVRAM config last updated at 13:54:27 CST Tue Feb 1 2005
> > > !
> > > version 12.2
> > > service timestamps debug datetime msec
> > > service timestamps log datetime msec
> > > service password-encryption
> > > !
> > > hostname WPG-SIPgw-01
> > > !
> > > boot system slot0:c7200-is-mz.122-15.T14.bin
> > > card type t1 1
> > > logging queue-limit 100
> > > enable secret 5 ***REMOVED***
> > > !
> > > clock timezone CST -6
> > > clock summer-time CDT recurring 1 Sun Apr 2:00 4 Sun Oct 2:00
> > > dspint DSPfarm1/0
> > > !
> > > ip subnet-zero
> > > !
> > > !
> > > ip cef
> > > !
> > > isdn switch-type primary-dms100
> > > !
> > > !
> > > !
> > > voice service voip
> > > sip
> > > !
> > > !
> > > !
> > > !
> > > !
> > > !
> > > !
> > > no voice hpi capture buffer
> > > no voice hpi capture destination
> > > !
> > > !
> > > mta receive maximum-recipients 0
> > > !
> > > !
> > > controller T1 1/0
> > > framing esf
> > > linecode b8zs
> > > cablelength long 0db
> > > pri-group timeslots 1-24
> > > !
> > > controller T1 1/1
> > > shutdown
> > > framing esf
> > > linecode b8zs
> > > cablelength long 0db
> > > !
> > > !
> > > !
> > > interface FastEthernet0/0
> > > ip address XXX.XXX.106.150 255.255.255.0
> > > duplex full
> > > !
> > > interface Serial1/0:23
> > > no ip address
> > > no logging event link-status
> > > isdn switch-type primary-dms100
> > > isdn incoming-voice voice
> > > no cdp enable
> > > !
> > > ip classless
> > > ip route 0.0.0.0 0.0.0.0 XXX.XXX.106.1
> > > no ip http server
> > > !
> > > !
> > > !
> > > access-list 10 permit XXX.XXX.106.4
> > > access-list 10 permit XXX.XXX.106.5
> > > !
> > > !
> > > call rsvp-sync
> > > !
> > > voice-port 1/0:23
> > > !
> > > !
> > > mgcp profile default
> > > !
> > > dial-peer cor custom
> > > !
> > > !
> > > !
> > > dial-peer voice 100 voip
> > > application session
> > > destination-pattern XXXXX54235
> > > progress_ind setup enable 3
> > > session protocol sipv2
> > > session target ipv4:XXX.XXX.99.50
> > > session transport udp
> > > !
> > > dial-peer voice 101 voip
> > > application session
> > > destination-pattern XXXXX54236
> > > progress_ind setup enable 3
> > > session protocol sipv2
> > > session target ipv4:XXX.XXX.102.59
> > > session transport udp
> > > !
> > > dial-peer voice 5000 pots
> > > application session
> > > destination-pattern .......
> > > direct-inward-dial
> > > port 1/0:23
> > > !
> > > dial-peer voice 102 voip
> > > application session
> > > destination-pattern XXXXX74002
> > > progress_ind setup enable 3
> > > session protocol sipv2
> > > session target ipv4:XXX.XXX.102.59
> > > session transport udp
> > > !
> > > dial-peer voice 103 voip
> > > application session
> > > destination-pattern XXXXX74003
> > > progress_ind setup enable 3
> > > session protocol sipv2
> > > session target ipv4:XXX.XXX.102.59
> > > session transport udp
> > > codec g711ulaw
> > > !
> > > dial-peer voice 104 voip
> > > application session
> > > destination-pattern XXXXX74004
> > > progress_ind setup enable 3
> > > session protocol sipv2
> > > session target ipv4:XXX.XXX.102.59
> > > session transport udp
> > > !
> > > dial-peer voice 105 voip
> > > destination-pattern XXXXX74005
> > > progress_ind setup enable 3
> > > session protocol sipv2
> > > session target ipv4:XXX.XXX.102.59
> > > session transport udp
> > > !
> > > dial-peer voice 5001 pots
> > > incoming called-number 1..........
> > > direct-inward-dial
> > > port 1/0:23
> > > prefix 1
> > > !
> > > sip-ua
> > > calling-info sip-to-pstn number set XXXXX74006
> > > !
> > > !
> > > gatekeeper
> > > shutdown
> > > !
> > > !
> > > line con 0
> > > stopbits 1
> > > line aux 0
> > > stopbits 1
> > > line vty 0 4
> > > access-class 10 in
> > > exec-timeout 60 0
> > > password ***REMOVED***
> > > login
> > > !
> > > ntp clock-period 17180028
> > > ntp server XXX.XXX.111.252
> > > !
> > > end
> > >
> > >
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
More information about the cisco-voip
mailing list