[cisco-voip] AS5350 problem

[Eric Knudson]

Medve, 

Perhaps you're missing an 'isdn incoming-voice voice' on the serial interface?

Could you post your configuration?

Eric



On Thu, 13 Jan 2005 16:53:15 +0100 (CET), Medve Istvan <imedve at ew.hu> wrote:
> Hi All,
> 
> suppose It's a simple problem but I cannot resolve.
> 
> I use as5350 as a media gateway between pstn and sip/voip. Incoming sip
> calls works fine. Incoming pstn calls have problem.
> 
> I have one voip dial-peer for test:
> 
> dial-peer voice 20 voip
>  destination-pattern 7701
>  session protocol sipv2
>  session target sip-server
> !
> 
> Calling this number from pstn I get the following:
> 
> an 13 16:21:29.869: ISDN Se3/0:15 Q931: RX <- SETUP pd = 8  callref = 0x0074
>         Sending Complete
>         Bearer Capability i = 0x9090A3
>                 Standard = CCITT
>                 Transer Capability = 3.1kHz Audio
>                 Transfer Mode = Circuit
>                 Transfer Rate = 64 kbit/s
>         Channel ID i = 0xA18381
>                 Preferred, Channel 1
>         Calling Party Number i = 0x0183, '6703'
>                 Plan:ISDN, Type:Unknown
>         Called Party Number i = 0x81, '7701'
>                 Plan:ISDN, Type:Unknown
> Jan 13 16:21:29.873: ISDN Se3/0:15 **ERROR**: call_incoming: Received a call id 0x6B with a bad bearercap from 6703 on b channel 1
> Jan 13 16:21:29.873: ISDN Se3/0:15 Q931: TX -> RELEASE_COMP pd = 8 callref = 0x8074
>         Cause i = 0x80D8 - Incompatible destination
> 
> If I use pots dial-peer to send back the call to the softswitch, works
> fine. (bearer cap no mather)
> 
> I cannot decide that pstn (softswitch) should configure (change bearer
> cap if can) or cisco's side ?
> 
> c5350-is-mz.123-11.T.bin is used.
> 
> Thanks,
> imedve
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>