[cisco-voip] Bat-phone functionality for IP phones?

[David]

Thank you all so much for the information, I had no idea this could be
done...  Good stuff!

On 7/8/05, Brian Henry <Brian.Henry at apptis.com> wrote:
> Yes!,
> Put the phone in its own Partition, lets say Elevator-pt
> Next create a partition for which you want that phone to dial, lets say security, secringdwn-pt, for Security Ring Down Partition.
> Create a CSS with just one Partition in it that you want that ringdown to call, secringdwn-pt.
> Put that CSS on the phones, device CSS or line CSS it doesn't matter
> Go to translations create a new one but for the pattern put "absolutely nothing"
> for the CSS have it be for the internal number that you want to call.
> Put in the called number translation to the number to what you want to call.
> 
> That's it
> 
> Brian
> 
> ________________________________
> 
> From: cisco-voip-bounces at puck.nether.net on behalf of David
> Sent: Fri 7/8/2005 2:03 PM
> To: cisco-voip at puck.nether.net
> Subject: [cisco-voip] Bat-phone functionality for IP phones?
> 
> 
> 
> Hello folks,
> 
> Does anyone know if it's possible to configure an IP phone (7902 in
> this case) to dial a particular number when it goes off-hook?  I know
> you can do this with analog phones via a PLAR on a Voice Gateways
> voice-port, but is there equivalent functionality in the IP world?
> 
> Thanks!
> 
> -David
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> 
> 
> 
>