[cisco-voip] Outbound Caller ID

[Wes Sisk]

Court,

That is only from the CM->gw, that does not reflect the analog signaling on
the CO line.

As Ryan indicated, I am not aware of any way to send CLID OUT an FXO port.
FXS can SEND, but FXO must receive.

/Wes

-----Original Message-----
From: Court Schuett [mailto:cschuett at hfsnorthamerica.com]
Sent: Tuesday, July 12, 2005 2:01 PM
To: Wes Sisk; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Outbound Caller ID


Here is the output of debug vpm all

   ----- ccCallInfo IE subfields -----
   cisco-ani=7707299500
   cisco-anitype=0
   cisco-aniplan=1
   cisco-anipi=0
   cisco-anisi=1
   dest=18005551212
   cisco-desttype=0
   cisco-destplan=0
   cisco-rdn=
   cisco-rdntype=-1
   cisco-rdnplan=-1
   cisco-rdnpi=-1
   cisco-rdnsi=-1

That is the correct number being passed out, but the number coming up on
caller id is incorrect still.

BTW, that is the same output as the debug voice ccapi inout



Court Schuett

630-909-5560
cschuett at hprlogistics.com

-----Original Message-----
From: Wes Sisk [mailto:wsisk at cisco.com]
Sent: Tuesday, July 12, 2005 11:14 AM
To: Court Schuett; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Outbound Caller ID

In debug voip ccapi inout are you passing out the correct CLID?

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net]On Behalf Of Court Schuett
Sent: Tuesday, July 12, 2005 12:11 PM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Outbound Caller ID


Some info:

We have a remote site with a 4 FXO POTS lines.  Calls are coming in and
out just fine.  No problems there.  Attached to each of those lines is a
local number.  When a call goes out voice-port 3/0 it goes out with the
number attached to that line (9508).  When a call goes out voice-port
3/1 it goes out with the number attached to that line (9506).

At every other of our sites set up like this, the External Number Mask
overrides the number on the line.  I have tried everything I can think
of to put the main number (9500) on all the lines to no avail.  I have
made sure that they are all set to advertise the External Number Mask.
I have even put the main number on the Calling Party Transform Mask in
the Route Pattern.  When I do a debug voice ccapi inout on the router,
it shows the number being advertised is correct (9500).  Nothing has
worked.

I have called the local provider (Bell South) and they swear that if I
pass them the number they'll advertise it.  That's where I think the
problem is though.  It's all I can think of because everything else
looks correct.  Is there a special trick to passing CID to Bell South or
am I missing something?

Thanks!

Court Schuett

630-909-5560
cschuett at hprlogistics.com

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip