[cisco-voip] codec difference in CME 3.3

[pedro marques]

Hi,

I have CME running in a cisco 3825 with IOS 12.4(1a).

I have my voice-port configured for compand type a-law, as you can see

hostname#sh voice port 0/0/0:15

ISDN 0/0/0:15 Slot is 0, Subslot is 0, Sub-unit is 0, Port is 15
Type of VoicePort is ISDN-VOICE
Operation State is DORMANT
Administrative State is UP
No Interface Down Failure
Description is not set
Noise Regeneration is enabled
Non Linear Processing is enabled
Non Linear Mute is disabled
Non Linear Threshold is -21 dB
Music On Hold Threshold is Set to -38 dBm
In Gain is Set to 0 dB
Out Attenuation is Set to 0 dB
Echo Cancellation is enabled
Echo Cancellation NLP mute is disabled
Echo Cancellation NLP threshold is -21 dB
Echo Cancel Coverage is set to 64 ms
Echo Cancel worst case ERL is set to 6 dB
Playout-delay Mode is set to adaptive
Playout-delay Nominal is set to 60 ms
Playout-delay Maximum is set to 250 ms
Playout-delay Minimum mode is set to default, value 40 ms
Playout-delay Fax is set to 300 ms
Connection Mode is normal
Connection Number is not set
Initial Time Out is set to 10 s
Interdigit Time Out is set to 10 s
Call Disconnect Time Out is set to 60 s
Ringing Time Out is set to 180 s
Wait Release Time Out is set to 30 s
Companding Type is A-law
Region Tone is set for PT
Station name None, Station number None
Translation profile (Incoming):
Translation profile (Outgoing):

but when I issue the command "show voice call status" this is what I
get (or by pressing the IP Phones' question mark (?) key twice while
connected):

hostname#sh voice call stat
CallID CID ccVdb Port DSP/Ch Called # Codec Dial-peers
0xA7 11F5 0x663D3A88 0/0/0:15.17 0/1:2 1018 g711ulaw 1/20019

0xA8 11F5 0x66B51158 50/0/19.0 *1018 g711ulaw 20019/1

0xAF 1302 0x66C23330 50/0/34.0 025....... g711ulaw 20034/2

0xB0 1302 0x663D3A88 0/0/0:15.31 0/1:1 *025....... g711ulaw 2/20034

0xB2 1308 0x66C09678 50/0/32.0 021....... g711ulaw 20032/2

0xB3 1308 0x663D3A88 0/0/0:15.30 0/1:3 *021....... g711ulaw 2/20032

0xB4 130B 0x66A67500 50/0/3.0 093....... g711ulaw 20003/1

0xB5 130B 0x663D3A88 0/0/0:15.29 0/1:4 *093....... g711ulaw 1/20003
4 active calls found

(for privacy reasons I replaced the actual numbers)

What would probably be wrong here?

best regards,

pmarques