[cisco-voip] translation rule - MGCP

[Ryan Ratliff]

It will work on any call to the destination specified in the 
translation rule.  If your calls come into the gateway as 4-digit 
numbers that match your internal extensions exactly then calls made 
from IP phones may hit the same translation patterns that calls from 
the gateway do.  Constructive use of partitions/CSS can avoid this.

-Ryan
On Jun 23, 2005, at 8:33 AM, Marcin Nowacki wrote:

I've always used translation patterns to change outgoing calls ( eg. 
Add prefix ). It will work with incoming numbers ?

Marcin

-----Original Message-----
From: Ryan Ratliff [mailto:rratliff at cisco.com]
Sent: Thursday, June 23, 2005 2:16 PM
To: Marcin Nowacki
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] translation rule - MGCP
You'll have to use translation patterns on the CM.

-Ryan
On Jun 23, 2005, at 6:49 AM, Marcin Nowacki wrote:

Hello

I would like to add translation rule to incoming numbers , I have CCM
4.1(3) with MGCP Gateway.

         Normally ( with H.323 configuration )  I would add it as
incoming translation rule to incoming E1 port but how to configure it
when we have MGCP configured. I would like to add rule as below:

translation-rule 1

 Rule 1 ^89 0

 Rule 2 ^1 001

 Rule 3 ^2 002

 Rule 4 ^3 003

 Rule 5 ^4 004

 Rule 6 ^5 005

 Rule 7 ^6 006

 Rule 8 ^7 007

 Rule 9 ^9 009

Where should I add it . Can it be configured somewhere on Call Manager ?

Greetings Marcin
_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip