[cisco-voip] NM-HDV2 and ISDN data backup

[Walenta, Phil]

The documentation is correct, but it really should state data isn't supported.  Any MFT-T1 or MFT-E1 card that based in an NM-HDV slot cannot be used for data because the carrier card is voice only.

However, if you used a 28XX router, or 38XX router, you could put the MFT-2T1/E1 card in a hwic slot, have internal DSP's, and I believe you could then split the duty of the card.  The only potential issue would be the line clocking.

Alternatively, I believe you could use a 26XX/36XX/37XX router with an AIM card for voice.

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net [mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Arkadiusz Kuczorski
Sent: Monday, May 09, 2005 8:26 AM
To: cisco-voip
Subject: [cisco-voip] NM-HDV2 and ISDN data backup

Hello All,

I need some advice regards NM-HDV2-2T1/E1. Does this module can be used to perform ISDN dial backup ?
Q&A (http://www.cisco.com/warp/public/cc/pd/nemnsw/callmn/prodlit/sopra_qa.pdf) is stated that it doesn't "...support integrated voice and serial WAN data access over PRI" but I wonder about "INTEGRATED voice and serial WAN". Is that mean voice and data couldn't be used on single interface, or at all ? Can I configure E1 PRI (voice) on one port and E1 PRI (Data) on the second and perform ISDN dial-in backup from other routers ?

TIA
Arek 

----------------------------------------------------
Rozmawiaj ze stacjonarnego do 95% taniej!
Zasięg Polska i 52 kraje sprawdź nas! -> telefon.wp.pl
http://klik.wp.pl/?adr=www.telefon.wp.pl&sid=373


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip