[cisco-voip] Inbound and outbound calls sometime fail

[Ruttman, Peter G.]

Nope, I didn't get any errors.  It came up just fine.  I was concerned
but happy that it wasn't an issue after all...until now of course.  I'll
check out the links.  Thanks.
 
Pete

-----Original Message-----
From: Brian Henry [mailto:Brian.Henry at apptis.com] 
Sent: Tuesday, November 22, 2005 10:02 AM
To: Ruttman, Peter G.
Subject: RE: [cisco-voip] Inbound and outbound calls sometime fail



Just by your first statement, did you receive an error when you
configured the pri-group or ds0-group, if you tried to turn up all
channels 1-24, that you did not have enough resources?

Use these references:

http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note0
9186a0080108fe6.shtml

 
http://www.cisco.com/en/US/products/sw/voicesw/ps556/products_tech_note0
9186a0080108fe6.shtml
 

Hope this helps you track down your issue.

 

Brian


  _____  


From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Ruttman, Peter
G.
Sent: Tuesday, November 22, 2005 10:51 AM
To: cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Inbound and outbound calls sometime fail

 

I have a hdvr2 card with 4 pdvm64 modules on it.  We added a second T1
to the router after the conferencing was setup.  I did shut down the
profile and adjusted the max sessions to the new value it offered.  I
did not reboot the router though.

 

How do I check and see if all my dsp resources have something to
terminate to?

 

Pete

-----Original Message-----
From: Brian Henry [mailto:Brian.Henry at apptis.com] 
Sent: Tuesday, November 22, 2005 9:30 AM
To: Ruttman, Peter G.
Subject: RE: [cisco-voip] Inbound and outbound calls sometime fail

Did you configure your PRI/CAS before you configured your sccp
conferencing or sccp profiles depends on which dsp's you have?

Did you look at your dsp resources to see if all your channels have
something to terminate to?

 

Brian

 


  _____  


From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Ruttman, Peter
G.
Sent: Tuesday, November 22, 2005 10:23 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Inbound and outbound calls sometime fail

 

I installed a new office a few weeks ago and I am getting occasional
reports of failed inbound and outbound calls.  On the inbound calls the
ip phones ring once and then get a busy tone.  On the router I see this
message appear within a few seconds:

 No dsps found either locally or globally! 

I have maxed out the sessions for conferencing on the router.  Could
that be the problem? 

Pete Ruttman 


The preceding email message may be confidential or protected by the
attorney-client privilege. It is not intended for transmission to, or
receipt by, any unauthorized persons. If you have received this message
in error, please (i) do not read it, (ii) reply to the sender that you
received the message in error, and (iii) erase or destroy the message.
Legal advice contained in the preceding message is solely for the
benefit of the Foley & Lardner LLP client(s) represented by the Firm in
the particular matter that is the subject of this message, and may not
be relied upon by any other party. 


Internal Revenue Service regulations require that certain types of
written advice include a disclaimer. To the extent the preceding message
contains advice relating to a Federal tax issue, unless expressly stated
otherwise the advice is not intended or written to be used, and it
cannot be used by the recipient or any other taxpayer, for the purpose
of avoiding Federal tax penalties, and was not written to support the
promotion or marketing of any transaction or matter discussed herein.


The preceding email message may be confidential or protected by the
attorney-client privilege. It is not intended for transmission to, or
receipt by, any unauthorized persons. If you have received this message
in error, please (i) do not read it, (ii) reply to the sender that you
received the message in error, and (iii) erase or destroy the message.
Legal advice contained in the preceding message is solely for the
benefit of the Foley & Lardner LLP client(s) represented by the Firm in
the particular matter that is the subject of this message, and may not
be relied upon by any other party. 


Internal Revenue Service regulations require that certain types of
written advice include a disclaimer. To the extent the preceding message
contains advice relating to a Federal tax issue, unless expressly stated
otherwise the advice is not intended or written to be used, and it
cannot be used by the recipient or any other taxpayer, for the purpose
of avoiding Federal tax penalties, and was not written to support the
promotion or marketing of any transaction or matter discussed herein.


The preceding email message may be confidential or protected by the attorney-client privilege. It is not intended for transmission to, or receipt by, any unauthorized persons.  If you have received this message in error, please (i) do not read it, (ii) reply to the sender that you received the message in error, and (iii) erase or destroy the message.  Legal advice contained in the preceding message is solely for the benefit of the Foley & Lardner LLP client(s) represented by the Firm in the particular matter that is the subject of this message, and may not be relied upon by any other party.      

  
Internal Revenue Service regulations require that certain types of written advice include a disclaimer. To the extent the preceding message contains advice relating to a Federal tax issue, unless expressly stated otherwise the advice is not intended or written to be used, and it cannot be used by the recipient or any other taxpayer, for the purpose of avoiding Federal tax penalties, and was not written to support the promotion or marketing of any transaction or matter discussed herein.

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20051123/fdd20dd3/attachment-0001.html