[cisco-voip] pstn gw question

[Ryan Ratliff]

Try adding "incoming called-number ." and "direct-inward-dial" to  
dial-peer 100.

-Ryan

On Oct 11, 2005, at 3:49 PM, Roeseler, David wrote:


dial-peer voice 100 pots
  destination-pattern 5551111
  port 2/0:0
!
dial-peer voice 200 voip
  destination-pattern 3561111
  session target ipv4:10.11.11.2




-----Original Message-----
From: Ryan Ratliff [mailto:rratliff at cisco.com]
Sent: Tuesday, October 11, 2005 1:59 PM
To: Roeseler, David
Cc: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] pstn gw question

What is your dial-peer configuration on the router?

-Ryan

On Oct 11, 2005, at 12:58 PM, Roeseler, David wrote:

I have setup my pstn gw with basic defaults and am just trying to get
intial connections.

  From the IP phone on the call manager when I dial a pstn number, I
get a dial tone after the

Seven digits, I then dial the number again and the call completes
successfully.


This is my setup

7970 - CCM4.1.3--3725/H323/1MFT1/à Atlas800 àFXS phone.


The fxs is 5551111

The ip is 3651111


The calls complete either direction, however I have to dial twice?



Dave Roeseler

System Engineer

Harris Corporation

droesele at harris.com



_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip