[cisco-voip] NM-HDV2-2T1/E1 and PVDM2

[Yinglam Cheung]

Hi,

After I read the doc for this module, I've a few questions since I never use
this:

1. can the on-board T1/E1 be configured as either T1 or E1? So both commands
"controller t1" and "controller e1" show up in the config for the same
slot/port?

2. if answer is yes to question 1, so you can configure one port as T1 and
the other E1 if you have two ports?

3. if answer is no to question 1, can you put in VWIC-T1 or VWIC-E1 to have
mixed T1 and E1 ports?

4. can you mix PVDM2 and PVDM in the same NM?

Thanks!