[cisco-voip] 6608 PRI to telco

[Lelio Fulgenzi]

What exactly are you looking for? Here are some starting points:

Device > Gateway > Add a new gateway > Cisco Catalyst 6000 T1 VoIP Gateway > Digital Access PRI

and fill in the appropriate parameters.

Your telco will have to answer many of the questions including network time server/client (usually client) and your switch type (DMS-100 mainly in Canada).

Add the mac address of the card from your blade. Do a show port mod to see the MAC addreses.

As far as programming the port itself, here's a typical config statement:

set port voice interface <mod>/<port> dhcp disable <ipaddr> <mask> vlan <vlan> tftp <tftpserverip> gateway <gatewayip>

<------------------------------------ expand window to fit this on one line ------------------------------------------>

Sometimes, you really have to hope and pray to get to configure the port correctly. Sometimes we have had to restart the entire blade to get it working, but usually you have to disable the port first, make the changes, then enable. If it still doesn't work, changing the vlan to an unused VLAN, say 999, then back again helps. We've had conflicting reports that say you have to have ALL your ports registered, whether you use them or not.....balderdash I say - but then again, I'm not CCIE. ;)

You'll also likely see two of these messages with a bit of time between them, don't go on to the next troubleshooting step unless you haven't seen any feed back for about five minutes:

%SYS-4-MODHPRESET:Host process (860) <mod>/<port> got reset asynchronously


--------------------------------------------------------------------------------
Lelio Fulgenzi, B.A.
Network Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
"I had a coffee and Coke at lunch today...and now, I've got more jitter than an
IP phone on a long haul 10base2 connection"                                           LFJ
  ----- Original Message ----- 
  From: Montejano, Ross 
  To: cisco-voip at puck.nether.net 
  Sent: Thursday, September 29, 2005 11:38 AM
  Subject: [cisco-voip] 6608 PRI to telco


  Hi,

   

  Does anyone have a link to turn up PRI trunks to the telco via a 6608 card, need a quick reference?

   

  TIA



------------------------------------------------------------------------------


  _______________________________________________
  cisco-voip mailing list
  cisco-voip at puck.nether.net
  https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20050929/80cfe2c7/attachment.html