[cisco-voip] how to config switch port into ethernet port

[Kevin Thorngren]

I am not familiar with the 1841 but I will try to help.

Are you talking about the 4 port EtherSwitch HWIC?

If so, this FAQ page may help:
http://www.cisco.com/en/US/products/ps5853/ 
products_qanda_item0900aecd8016c026.shtml

It has this question:
Q. Do the Cisco EtherSwitch HWICs support Layer 2 switching and  
inter-VLAN routing through the router CPU?

A. Yes, the Cisco EtherSwitch HWICs support Layer 2 switching for  
traffic between all their ports belonging to the same VLAN. For  
inter-VLAN traffic, the Layer 3 VLAN interface, representing a VLAN at  
Layer 3, is used for routing. All the Layer 2 traffic in a VLAN  
destined for routing goes to the Layer 3 VLAN interface. This Layer 3  
VLAN interface is supported in conjunction with the Cisco EtherSwitch  
HWIC to route traffic at Layer 3. Access control lists, routing, and IP  
addressing can be applied on this Layer 3 interface.

The config guide for this module provides an example of inter-vlan  
routing:
http://www.cisco.com/en/US/products/sw/iosswrel/ps5207/ 
products_feature_guide09186a00802c6bb6.html#wp1051418

HTH,
Kevin

On Sep 29, 2005, at 9:22 PM, ajames grace wrote:

> how to config a switch port as a ethernet port on my 1841 router.  i  
> was told something about route mode, but not sure how to do  
> it._______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
-------------- next part --------------
A non-text attachment was scrubbed...
Name: not available
Type: text/enriched
Size: 1517 bytes
Desc: not available
Url : https://puck.nether.net/pipermail/cisco-voip/attachments/20050930/28d459b5/attachment.bin