[cisco-voip] Transcoding Problems - 2821 router with PVDM2-48

[Jason Evans]

Hi, Jason.

So how I understand Conf bridge located in the HQ,  and belong to the DP which doesn't contain transcoding resources ?

>> Correct

If so, insert this transcoding to the this DP.

>> Ok, so I put the transcoder into the HQ DP but it's the same result. 

Because when you call from remote location to the HQ phone, you use transcoding but when you initiate a conference, you take another resource and this resource
must also have knowledge where take transcoding.

>> So do I need a transcoding resource on each side? IE, do I have to configure my GW at HQ to use local transcoding resources as well? This makes sense, but I asked this up front and didn't get a response, so I didn't figure it was necessary. 

Another way, configure dspfarm also like conf bridge.

>> This sounds like it might be easier. 

-----------------------
Sincerely Yours,
Konstantin Fedorov
________________________________________
From: Jason Evans [mailto:JEvans at glgroup.com] 
Sent: Tuesday, April 18, 2006 9:24 PM
To: Fedorov, Konstantin; Kevin Thorngren
Cc: cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Transcoding Problems - 2821 router with PVDM2-48

Hi Konstantin,

Right now I'm speaking g711 across the WAN so they use CCM resources. I know - its not an efficient or scalable solution, but our remote offices started small and are now growing rapidly, therefore its now imperative that I speak a lower bw codec to the WAN sites. 

jason

________________________________________
From: Fedorov, Konstantin [mailto:kfedor at amt.ru] 
Sent: Tuesday, April 18, 2006 12:11 PM
To: Jason Evans; Kevin Thorngren
Cc: cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Transcoding Problems - 2821 router with PVDM2-48

Hi,

What conference bridge do you use for remote phones ??

Does this conf bridge belong to the DP which also have transcoding resources ?

-----------------------
Sincerely Yours,
Konstantin Fedorov