[cisco-voip] Why do my dialpeer pots are not active?

[Fedorov, Konstantin]

Hi,

 

This is normal. When ISDN L1 deactivated, pots dial-peer not active

 

Try this solution

http://www.ciscotaccc.com/kaidara-advisor/accessdial/showcase?case=K2309
5837

-----------------------
Sincerely Yours,
Konstantin Fedorov

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Anthony
Kouloglou
Sent: Tuesday, April 25, 2006 1:51 PM
To: cisco-voip at puck-nether.net
Subject: [cisco-voip] Why do my dialpeer pots are not active?

 

Hi all,
i am running 12.3.14T7 spservices early deployment ios on a 2811 router
(but i also faced the same problem with other non deferred 12.3 ios in
2801 routers).
-There are 4 BRIs on that router. 
-The show isdn status shows that Layer 1 is DEACTIVATED.
-The show dialplan number xxxx does not match any dialpeer (even though
there are 4 dialpeer pots, one for each voice-port) and so i cannot have
any outside call 
-When i issue the command isdn test call interface bri 0/x/x <number>,
the interface status gets up (Layer 1 also) and the router's dialplan is
working now with no problem. Even the command show dialplan number xxx
shows the match to each dialpeer now,
-After a while, the Layer 1 gets deactiveted and the dialpeer fail to
match again and so i do not have outside calls!!

Is this a bug of the new IOS? I don't think that this behaviour occured
at oldest IOSs

Thanks
Anthony

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060425/d92d1cc9/attachment-0001.html