[cisco-voip] Why do my dialpeer pots are not active?

Fedorov, Konstantin kfedor at amt.ru
Tue Apr 25 10:13:21 EDT 2006


Hi, 

 

Well,  

Can you send a BRI config to this list ??

 

Do you talk with provider to activate BRI always ? I suppose that
provider configure ISDN BUS,

Is this possible configure p2p ISDN ??

 

-----------------------
Sincerely Yours,
Konstantin Fedorov

  _____  

From: Anthony Kouloglou [mailto:akoul at dataways.gr] 
Sent: Tuesday, April 25, 2006 5:42 PM
To: Fedorov, Konstantin
Cc: cisco-voip at puck-nether.net
Subject: Re: [cisco-voip] Why do my dialpeer pots are not active?

 

Hi,
thanks a lot. I have seen that link, i tried the command "isdn
tei-negotiation first call" but it didn't work. 
I don't think that it is a problem of the BRI but of the Dial-peer.
As soon soon as the Layer 1 gets deactivated, the show dialplan number
xxx command is working for a few more minutes!!! And then, as if there
is timeout or somethng like that, the dialpeer is not found and so no
calls can be made from the specific dialpeer!!

Also, don't forget that i am always capable of making an isdn test call
and bring the interface in an Active mode. That is why i don't think
that it has something to do with the bri configuration.

Regards,
Anthony Kouloglou

Fedorov, Konstantin wrote: 

Hi,

 

This is normal. When ISDN L1 deactivated, pots dial-peer not active

 

Try this solution

http://www.ciscotaccc.com/kaidara-advisor/accessdial/showcase?case=K2309
5837

-----------------------
Sincerely Yours,
Konstantin Fedorov

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Anthony
Kouloglou
Sent: Tuesday, April 25, 2006 1:51 PM
To: cisco-voip at puck-nether.net
Subject: [cisco-voip] Why do my dialpeer pots are not active?

 

Hi all,
i am running 12.3.14T7 spservices early deployment ios on a 2811 router
(but i also faced the same problem with other non deferred 12.3 ios in
2801 routers).
-There are 4 BRIs on that router. 
-The show isdn status shows that Layer 1 is DEACTIVATED.
-The show dialplan number xxxx does not match any dialpeer (even though
there are 4 dialpeer pots, one for each voice-port) and so i cannot have
any outside call 
-When i issue the command isdn test call interface bri 0/x/x <number>,
the interface status gets up (Layer 1 also) and the router's dialplan is
working now with no problem. Even the command show dialplan number xxx
shows the match to each dialpeer now,
-After a while, the Layer 1 gets deactiveted and the dialpeer fail to
match again and so i do not have outside calls!!

Is this a bug of the new IOS? I don't think that this behaviour occured
at oldest IOSs

Thanks
Anthony

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060425/0df8ad0d/attachment.html 


More information about the cisco-voip mailing list