[cisco-voip] DSP Activation

[Jozef Janitor]

How to activate DSPs on the Cisco 2811 router? It has NM-HDV2 PVDM2 module.

CME2#sh dspfarm dsp all

Total number of DSPFARM DSP channel(s) 0

CME2#sh dsp all
DSPFARM Configuration Information:
Admin State: DOWN, Oper Status: DOWN - Cause code: ADMIN_STATE_DOWN
Transcoding Sessions: 0(Avail: 0), Conferencing Sessions: 0 (Avail: 0)
Trans sessions for mixed-mode conf: 0 (Avail: 0), RTP Timeout: 600
Connection check interval 600 Codec G729 VAD: ENABLED

Total number of active session(s) 0, and connection(s) 0


Total number of DSPFARM DSP channel(s) 0

Dspfarm Profile Configuration

 Profile ID = 10, Service = TRANSCODING, Resource ID = 1
 Profile Description :
 Profile Admin State : DOWN
 Profile Operation State : DOWN
 Application : None   Status : NOT ASSOCIATED
 Resource Provider : FLEX_DSPRM   Status : NONE
 Number of Resource Configured : 0
 Number of Resource Available : 0
 Codec Configuration


I want to use them for transcoding from g711 to g729 on WAN side.
Could you please provide some sample config?

Thank you.

Regards,
  Jozef Janitor