[cisco-voip] SRST - ephones register to gatekeeper

[Ted Nugent]

Hey Andy
How about "security e164" under the GK config? I've
not set it up but I was reading about it a few months
back and if I remember correctly it sounds like it
might be what you're looking for? Just a thought.

Ted


--- Andrew Dignan <cisco at dignans.com> wrote:

> I have an interesting one here that I can't seem to
> work around.
> 
> Lets say CallManager goes down but the gatekeepers
> stay up.  The remote
> sites will go into SRST and register to the local
> gateway.  The gateway
> will then register its phones as e164 address to the
> gatekeeper.
> 
> The problem is that once the phones come out of
> SRST, the gatekeeper now
> has these e164 address registered to the gatekeeper
> and it causes problems
> with call routing.
> 
> I don't see any way under call-manager-fallback to
> tell the gateway to not
> register its ephones with the gatekeeper.  You can
> add no-reg after the
> dialplan command but the actual ephone dn's
> themselves will still register
> with the gatekeeper.
> 
> I have tried adding the command "no rrq
> dynamic-prefixes-accept" to the
> gatekeeper but they still register to the
> gateekeper.
> 
> **This is SRST, not CME so I can't add no-reg after
> the ephone
> configuratio because these ephones are dynamic with
> SRST.
> 
> tia,
> 
> Andrew B. Dignan, CCIE Voice #16528
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> 


__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com