[cisco-voip] Phone Rings & Volume Set to Defaults After Reboot

[Johan Bloemhard]

I looked and didn't see "Save" under settings.  I only have the default
menus: 1) User Preferences, 2) Network Configuration, etc.  

 

If you are talking about the "Save" softkey that appears after you
adjust the volume, I press that.  I only have the "Save" softkey for
adjusting the handset volume and not the ring volume.

 

As an example, if I set the ring volume at max, power cycle the phone,
the ring volume will be in the middle range.

 

Any advice for saving the ring preferences?

 

Johan Bloemhard 
Senior Information Technology Specialist 
___________________________________ 
Silver Falls School District 4J 
802 Schlador Street 
Silverton, OR 97381 
w: 503.873.6331 

________________________________

From: Lelio Fulgenzi [mailto:lelio at uoguelph.ca] 
Sent: Thursday, August 31, 2006 8:50 AM
To: Johan Bloemhard; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Phone Rings & Volume Set to Defaults After
Reboot

 

Press Settings, then Save.

 

This should keep configs throughout a reset. This included handset,
speaker and headset volume.

 

 

------------------------------------------------------------------------
--------
Lelio Fulgenzi, B.A.
Senior Analyst (CCS) * University of Guelph * Guelph, Ontario N1G 2W1
(519) 824-4120 x56354 (519) 767-1060 FAX (JNHN)
^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^^ 
"I can eat fifty eggs." "Nobody can eat fifty eggs."

	----- Original Message ----- 

	From: Johan Bloemhard
<mailto:bloemhard_johan at silverfalls.k12.or.us>  

	To: cisco-voip at puck.nether.net 

	Sent: Thursday, August 31, 2006 11:47 AM

	Subject: [cisco-voip] Phone Rings & Volume Set to Defaults After
Reboot

	 

	The office personnel would like to have their main incoming line
set to a common ring and volume, and unique rings for their personal DN.
The main driver is that a higher emphasis is placed on answering the
main incoming line than their personal DN.

	 

	For instance, they pick what they want for their personal DN
customized ring as the "Default Ring" and then for the second DN, I
choose "Ring 3" (which should be the common incoming ring).  I also make
adjustments to their ring volume.

	 

	However, whenever the phone is rebooted, the "Default Ring" is
kept but the second DN is now set to the same as "Default Ring" rather
than "Ring 3".  Additionally the volume defaults back to the midpoint in
the range.

	 

	These phones are 7941s.

	 

	Is this normal behavior? 

	 

	Johan Bloemhard 
	Senior Information Technology Specialist 
	___________________________________ 
	Silver Falls School District 4J 
	802 Schlador Street 
	Silverton, OR 97381 
	w: 503.873.6331 

	 

	
________________________________


	Disclaimer: This message may be legally privileged and/or is
intended only for the use of the addressee(s). The content and views
expressed in this email may represent the views of the sender and not
those of Silver Falls School District. 

	
________________________________


	_______________________________________________
	cisco-voip mailing list
	cisco-voip at puck.nether.net
	https://puck.nether.net/mailman/listinfo/cisco-voip

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060831/ae04a6b5/attachment-0001.html