[cisco-voip] forward-digits or caller-id

[Curt Shaffer]

Thanks. So if I have this right it should be like this:

Numbers are 703-555-XXXX where the X are the extension numbers

Telephony-service

Dialplan-pattern 1 703-555.... extension-length 4 extension-pattern ....


So when extension 1234 dials out it will pass 703-555-1234 to the provider?

Sorry for my inexperience with this but they did not have this trouble with
their old provider, I guess they took care of setting this. Can anyone give
me a reason their current provider couldn't do this as well other than
laziness?

Thanks

-----Original Message-----
From: Erick Bergquist [mailto:erickbe at yahoo.com] 
Sent: Wednesday, December 06, 2006 9:23 AM
To: Curt Shaffer; cisco-voip-bounces at puck.nether.net;
cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] forward-digits or caller-id

There are a couple ways this can be done.

Under the telephony-service, you can use the dialplan-pattern command to do
this. An example would be 'dialplan-pattern 1 414555.... extension-length
4'. 

You can also use translation profile/rule on the dial-peers to modify the
calling party number, or
under the ISDN D Channel, you can hard set the caller id also for all calls.

The forward-digits command, applies to the number called and how many digits
of that to send so doesn't effect the calling party number. For example if
you had forward-digits all on a dial-peer with destination-pattern of 9T and
you called 918005532447 it would send 918005532447 to PSTN or whereever
dial-peer was sending call to. A forward-digits of 10 would send 8005532447,
forward-digits of 4 would send 2447 and so forth.

HTH,  Erick



-----Original Message-----
From: "Curt Shaffer" <cshaffer at gmail.com>
Date: Wed, 6 Dec 2006 05:49:29 
To:<cisco-voip at puck.nether.net>
Subject: [cisco-voip] forward-digits or caller-id

I am a bit confused. A new phone company for a client of mine is telling
them they need to pass 10 digits to them, where as now they are apparently
only passing 4, thus callerid to outside users is showing up as only the
last 4 digits. My question is, is this accomplished by setting the caller-id
= local on the ephone-dn or is this accomplished by forward-digits 10 (or
all) on the dial peer for the 23 channels of the PRI?

Thanks

Curt

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip


_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip





 
____________________________________________________________________________
________
Do you Yahoo!?
Everyone is raving about the all-new Yahoo! Mail beta.
http://new.mail.yahoo.com