[cisco-voip] CCM 5.0 with CUE and SRST

[Erick Bergquist]

 You can have both a SIP and a JTAPI trigger set up and active on CUE at same time. You would use a SIP dial-peer on the router to route call to the CUE (check the CME/CUE cisco docs for sample configurations and setup - may need to adjust the preference on the dial-peer depending on what you are doing). 

I have worked on a few where there are multiple sites with CUEs with JTAPI integration back to CCM, and H.323 gateway. When CCM is not responding, the call goes to CUE via higher preference dial-peer configured as SIP with session target of CUE. 

What are you looking to do with the calls? The setup could be a simple setup to a more complex depending on what you want. Are your gateways H.323 or MGCP - doing MGCP Fallback with SRST if MGCP?

----- Original Message ----
From: Anthony Kouloglou <akoul at dataways.gr>
To: "cisco-voip at puck-nether.net" <cisco-voip at puck.nether.net>
Sent: Friday, December 15, 2006 7:28:57 AM
Subject: [cisco-voip] CCM 5.0 with CUE and SRST

If there is an existing implementation with CCM 5.0 and CUE, and the 
remote site has CUE locally,
is it possible to configure SRST to the remote site so it can cooperate 
with cue in case of the communication with ccm is lost?

Thanks

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip




__________________________________________________
Do You Yahoo!?
Tired of spam?  Yahoo! Mail has the best spam protection around 
http://mail.yahoo.com