[cisco-voip] H323 and MGCP simultaneously on gateway?

[Jonathan Charles]

However,

Theoretically, if you had H.323 dial-peers (without the service mgcp), they
should match any H.323 calls that hit the gateway.

So, if you created two different route-lists one for MGCP and one for
H.323and sent calls to the same gateway, they both should work.


HOWEVER,

If the controller T1 says service mgcp after the timeslots command, there is
a high probability that H.323 will NOT work (as the circuit is being
controlled by CCM).

What could work is if you had a PRI and a T1 CAS and controlled the PRI via
MGCP and the T1 CAS via H.323...

But I would need to see it actually doing stuff before believing it would
work...


Jonathan


On 12/15/06, Jonathan Charles <jonvoip at gmail.com> wrote:
>
> So, I guess that wouldn't be 'simultaneously...'
>
>
>
> Jonathan
>
> On 12/15/06, Jonathan Charles <jonvoip at gmail.com > wrote:
> >
> > I have done it.
> >
> > Configured both and set the H.323 as a second choice on the route list,
> > and then killed MGCP, calls still worked fine.
> >
> >
> >
> >
> > Jonathan
> >
> > On 12/15/06, Wydra, Jason <jason.wydra at berbee.com> wrote:
> >
> > >  Can you? I guess the better question is if it's supported.
> > >
> > >
> > >
> > > Jason Wydra
> > >
> > > Berbee
> > >
> > > Cisco Voice Engineer
> > >
> > > 8725 West Higgins Road, Suite 700
> > >
> > > Chicago, Il . 60631
> > >
> > > IP phone 773.867.6084
> > >
> > > Cell 630-209-9792
> > >
> > > Jason.Wydra at berbee.com
> > >
> > > www.berbee.com
> > >
> > >
> > >
> > > _______________________________________________
> > > cisco-voip mailing list
> > > cisco-voip at puck.nether.net
> > > https://puck.nether.net/mailman/listinfo/cisco-voip
> > >
> > >
> > >
> >
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20061215/ed4795cf/attachment.html