[cisco-voip] Translate Calling Number

[pnowicki at neo.rr.com]

I assume that you have 85264 setup as a dialable number in the system 
today. What you will need to do is set that DN/Route pattern off into 
it's own little partition. Create a calling search space that contains 
that partition. Create a translation pattern of 85264 within the 
partition that you had the original instance of the number in. Give it 
the Calling Search space that you just created. No transformation on 
the called number. For the calling number transformation mask, do 
8281347, or "XXXXXXX" if you want to pass just the last seven digits 
of the original called number.

Hope this helps!
-Patrick

----- Original Message -----
From: "Ruben Montes (EU)" <Ruben.Montes at eu.didata.com>
Date: Tuesday, February 7, 2006 10:31 am
Subject: [cisco-voip] Translate Calling Number

> Hi,
> 
> I'm using MGCP protocol and I want to do a translation on the calling
> number. 
> Number 028281347 calls 85264 (p.e.): I want to strip the 028 to the
> calling number, that is a number 'behind' an analog PBX connected 
> with a
> QSIG to the gateway.
> Which translation pattern should I create?
> 
> Regards,
> 
> Ruben
> 
> -----Mensaje original-----
> De: Wes Sisk [mailto:wsisk at cisco.com] 
> Enviado el: jueves, 02 de febrero de 2006 3:02
> Para: Ruben Montes (EU)
> CC: cisco-voip at puck.nether.net
> Asunto: Re: [cisco-voip] Applying mgcp changes
> 
> No, changes will not be propagated.
> 
> Take a look in the CCM traces at the time you see an error similar 
to:
> MGCPBhHandler 10.1.230.10 - ERROR - MGCPNotificationRequest for  
> reset: TCP Mgt not supported by the GW.  Sending MGCP err back to  
> reload device. GWTCPOpened=1, GWRegistered=1|<CLID::CM3-
> Cluster><NID:: 
> 11.1.235.50><CT::1,100,86,1.25><IP::><DEV::>
> 
> Basically indicating CM cannot send the change notification to the 
> 
> gateway.
> 
> 'no mgcp' , 'mgcp'
> will be required.
> 
> /Wes
> 
> 
> 
> On Feb 1, 2006, at 11:31 AM, Ruben Montes ((EU)) wrote:
> 
> Hi,
> 
> if I'm not using the ccm-manager config and ccm-manager config 
> server  
> commands, when I do a change in the CCM MGCP endpoint page and I  
> reset the gateway, is this change applied in the gateway?
> 
> I want to change the call classification from 'Use system default' 
> to  
> 'OnNet'. How could I now if changes have been correctly propagated?
> 
> Thanks in advance,
> 
> Regards,
> 
> Ruben
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> 
> 
> 
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>