[cisco-voip] SRST Dial peer

[Kevin Thorngren]

Yes, you will need H323 pots dial peer(s) for inbound and outbound  
calls to work when in SRST.  Depending on how you have the GW  
configured (ccm-manager commands) CallManager can configure the MGCP  
dial-peers but it won't configure the dial-peers needed when in SRST.   
When the router is in SRST MGCP is not used anymore and H323 takes  
over.  This URL provides a simple example of this:
http://www.cisco.com/en/US/tech/tk1077/ 
technologies_configuration_example09186a008012ecc6.shtml

You can use the same dial peers for both MGCP and H323 as in the  
example or you can create new dial peers just for H323 when in SRST.

Kevin
On Feb 23, 2006, at 7:51 AM, Gary Roberton wrote:

> Hi
>
>  Can anyone clarify the need for dial peers with an MGCP gateway  
> running SRST 3.3.  I cannot get the router to dial in or our without a  
> POTS dial peer even though I am using a
> dialplan-pattern and a transfer-pattern.  Is it right that a POTS dial  
> peer is required?  I seem to recall that the router can donfigure dial  
> peers itself on the fly.
>
>  Regards
>
>  Gary
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip