[cisco-voip] H323 call routing via GK (updated)

[Ciscozest]

Here is my dial plan config on CME router (Note that I have updated
some config) :
!
translation-rule 1
 rule 1 ^90016221 9 (updated)
!
dial-peer voice 1 pots
 incoming-called-number .
 direct-inward-dial
!
dial-peer voice 2 pots
 destination-pattern 90016221.......
 direct-inward-dial
 preference 1
 port 2/0:15
!
dial-peer voice 3 pots
 destination-pattern 9T
 direct-inward-dial
 port 2/0:15
!
dial-peer voice 23 voip
 destination-pattern 90016221.......
 translate-outgoing called 1
 session target ras
 tech-prefix 1# (added)
 dtmf-relay h245-alphanumeric
 no vad
!
GateKeeper config:
====================
Zone local xxxx test.com 172.16.12.254
Zone prefix xxxx 28.. gw-priority 10 JKT_1
Zone prefix xxxx 28.. gw-priority 5 JKT_2
Zone prefix xxxx 11.. gw-priority 10 BDG
Zone prefix xxxx 9....... gw-priority 10 JKT_1 (updated)
Zone prefix xxxx 9....... gw-priority 5 JKT_2  (updated)
Gw-type-prefix 1#
Bandwidth total zone xxxx 64

I would like ask:
- With the dial-peer voice 23, when I dialed "90016221XXXXXXX" from
CME site, the digits sent to GK will be "1#9XXXXXXX". The GK will have
a match ie:
4w2d: rassrv_get_addrinfo: (1#96694456) Matched tech-prefix 1#
4w2d: rassrv_get_addrinfo: (1#96694456) Matched zone prefix 9 and
remainder 6694456

>From this point, I assume the digits sent to CallManager will be
1#96694456 (plz correct me if I am wrong),
and it will strip tech prefix 1# and then CallManager will try to
match with its dial patterns. I have configured dial-pattern of
- 9.[1-9]XXXXXX with predot discard digit route to local gateway

The gatekeeeper controlled trunk has parameters under Inbound Calls:
- Significant Digits = All (Updated)
- CSS = HQ-all

All direct PSTN and 4 digit dialing calls are fine. Only calls that
are routed to CallManager from CME site always failed. Anything that
I missed?

Hi Kevin,
I have changed the translation rule as well but the resutl still same. thanks



On 1/16/06, Kevin Thorngren <kthorngr at cisco.com> wrote:
> You might need to change your Translation Rule to this:
> translation-rule 1
>  rule 1 ^90016221……. 6221
>
> Please refer to this page for more info on Translation Rules:
> http://www.cisco.com/en/US/partner/tech/tk652/tk90/
> technologies_configuration_example09186a0080094681.shtml
>
> Kevin
>
> On Jan 15, 2006, at 7:21 AM, Robin H wrote:
>
> > I have one voice gateway running H323 and another gateway is running
> > CME. I want to save IDD cost with toll bypass but having problem with
> > call routing via gatekeeper.
> >
> > Route-pattern config at CallManager:
> > 28XX -> route to gatekeeper
> > 11XX -> route to gatekeeper
> >
> >  GK config:
> >  Zone local xxxx test.com 172.16.12.254
> >  Zone prefix xxxx 28.. gw-priority 10 JKT_1
> >  Zone prefix xxxx 28.. gw-priority 5 JKT_2
> >  Zone prefix xxxx 11.. gw-priority 10 BDG
> >  Zone prefix xxxx 6221……. gw-priority 10 JKT_1
> >  Zone prefix xxxx 6221……. gw-priority 5 JKT_2
> >  Gw-type-prefix 1#
> >  Bandwidth total zone xxxx 64
> >
> > config at BDG router (CME):
> > translation-rule 1
> >  rule 1 ^90016221 6221
> > !
> > dial-peer voice 23 voip
> >  destination-pattern 90016221…….
> >  translate-outgoing called 1
> >  session target ras
> >  dtmf-relay h245-alphanumeric
> >  no vad
> > =========================
> >
> > Info:
> > 28XX is the extension in JKT site
> > 11XX is the ext in BDG site running CME 3.2
> > JKT and BDG gateways are registered as H323 devices in CM 3.3 with
> > significant-digits = 4.
> >
> >
> > Dial Test from BDG:
> > -         Dial 28XX is working fine
> > -         Dial 11XX is working fine
> > -         Dial to 90016221XXXXXXX (toll bypass) always failed.
> >
> > Plz enlighten me. thanks
> >
> > _______________________________________________
> > cisco-voip mailing list
> > cisco-voip at puck.nether.net
> > https://puck.nether.net/mailman/listinfo/cisco-voip
> >
>
>