[cisco-voip] No alerting tone on voip gateway
Anthony Kouloglou
akoul at dataways.gr
Thu Jan 19 12:20:34 EST 2006
Thanks Scott and Theodore,it is working now!!
All it needed was progress_ind alert enable 8
Voll, Scott wrote:
> I can't believe after 2 or 3 years I still have the config.
>
>
>
> Here is what I had:
>
>
>
> dial-peer voice 1 pots
>
> destination-pattern 4[5-8]..
>
> progress_ind alert enable 8
>
> progress_ind progress enable 8
>
> progress_ind connect enable 8
>
> direct-inward-dial
>
> port 1/0:23
>
> forward-digits all
>
> !
>
> dial-peer voice 100 voip
>
> destination-pattern 59..
>
> progress_ind setup enable 3
>
> voice-class codec 20
>
> session target ipv4:10.200.102.31
>
> dtmf-relay h245-alphanumeric
>
> !
>
>
>
> Scott
>
>
>
> ------------------------------------------------------------------------
>
> *From:* Anthony Kouloglou [mailto:akoul at dataways.gr]
> *Sent:* Thursday, January 19, 2006 9:01 AM
> *To:* Voll, Scott
> *Cc:* cisco-voip at puck-nether.net
> *Subject:* Re: [cisco-voip] No alerting tone on voip gateway
>
>
>
> It is h323 Scott.
> I had to add "progress_ind setup enable 3" at the voip dial peer,
> because without this,
> the alcatel phone could not hear the alerting either.
> I have tried many comands on the pots dialpeer but NOTHING!!
>
> Voll, Scott wrote:
>
> H323 or mgcp? H323 in the dial peer you can add a command something
> like progress indicator 3. This fixed it for my PBX when I was
> running h323. IF it's mgcp, I'm not sure.
>
>
>
> Scott
>
>
>
> ------------------------------------------------------------------------
>
> *From:* cisco-voip-bounces at puck.nether.net
> <mailto:cisco-voip-bounces at puck.nether.net>
> [mailto:cisco-voip-bounces at puck.nether.net] *On Behalf Of *Anthony
> Kouloglou
> *Sent:* Thursday, January 19, 2006 8:16 AM
> *To:* cisco-voip at puck-nether.net <mailto:cisco-voip at puck-nether.net>
> *Subject:* [cisco-voip] No alerting tone on voip gateway
>
>
>
> Hi all,
> i have a ccm ip network and a voip gateway which is connected with an
> alcatel PBX with isdn Q-SIG.
> When i call an alcatel extension from the ip phone, i get no alerting
> tone on the IPphone, although the alcatel phone is ringing (here is
> the debugging of the isdn q931)
>
> *Mar 4 00:11:12.070: ISDN BR1/0 Q931: TX -> SETUP pd = 8 callref =
> 0x0030
> Bearer Capability i = 0x8090A3
> Standard = CCITT
> Transer Capability = Speech
> Transfer Mode = Circuit
> Transfer Rate = 64 kbit/s
> Channel ID i = 0xA98382
> Exclusive, Channel 2
> Calling Party Number i = 0x0981, '125'
> Plan:Private, Type:Unknown
> Called Party Number i = 0x80, '128'
> Plan:Unknown, Type:Unknown
> Sending Complete
> *Mar 4 00:11:12.214: ISDN BR1/0 Q931: RX <- CALL_PROC pd = 8 callref
> = 0x8030
> Channel ID i = 0xA98382
> Exclusive, Channel 2
> **Mar 4 00:11:12.394: ISDN BR1/0 Q931: RX <- ALERTING pd = 8 callref
> = 0x8030*
> *Mar 4 00:11:18.434: ISDN BR1/0 Q931: RX <- DISCONNECT pd = 8
> callref = 0x0019
> Cause i = 0x8590 - Normal call clearing
> *Mar 4 00:11:18.438: ISDN BR1/0 Q931: TX -> RELEASE pd = 8 callref =
> 0x8019
> Cause i = 0x8090 - Normal call clearing
> *Mar 4 00:11:18.490: ISDN BR1/0 Q931: TX -> DISCONNECT pd = 8
> callref = 0x0030
> Cause i = 0x8290 - Normal call clearing
> *Mar 4 00:11:18.558: ISDN BR1/0 Q931: RX <- RELEASE_COMP pd = 8
> callref = 0x0019
> *Mar 4 00:11:18.774: ISDN BR1/0 Q931: RX <- RELEASE pd = 8 callref =
> 0x8030
> Cause i = 0x8190 - Normal call clearing
> *Mar 4 00:11:18.778: ISDN BR1/0 Q931: TX -> RELEASE_COMP pd = 8
> callredial-peer cor custom
>
> If i call another external call iget alering tone!!!(here is the isdn
> q931)
>
> *Mar 4 00:16:34.450: ISDN BR1/0 Q931: TX -> SETUP pd = 8 callref =
> 0x0031
> Bearer Capability i = 0x8090A3
> Standard = CCITT
> Transer Capability = Speech
> Transfer Mode = Circuit
> Transfer Rate = 64 kbit/s
> Channel ID i = 0xA98381
> Exclusive, Channel 1
> Calling Party Number i = 0x0081, '210'
> Plan:Unknown, Type:Unknown
> Called Party Number i = 0x80, '02310469300'
> Plan:Unknown, Type:Unknown
> Sending Complete
> *Mar 4 00:16:34.606: ISDN BR1/0 Q931: RX <- CALL_PROC pd = 8 callref
> = 0x8031
> Channel ID i = 0xA98381
> Exclusive, Channel 1
> **Mar 4 00:16:36.386: ISDN BR1/0 Q931: RX <- ALERTING pd = 8 callref
> = 0x8031 **
> Progress Ind i = 0x8488 - In-band info or appropriate now
> available *
> *Mar 4 00:16:38.638: ISDN BR1/0 Q931: RX <- CONNECT pd = 8 callref =
> 0x8031
> Progress Ind i = 0x8082 - Destination address is non-ISDN
> Connected Number i = 0x41833137383932333130343639333030
> *Mar 4 00:16:38.642: ISDN BR1/0 Q931: TX -> CONNECT_ACK pd = 8
> callref = 0x0031
> *Mar 4 00:16:41.710: %ISDN-6-CONNECT: Interface BRI1/0:1 is now
> connected to unknown
> *Mar 4 00:16:41.710: %ISDN-6-DISCONNECT: Interface BRI1/0:1
> disconnected from unknown , call lasted 3 seconds
> *Mar 4 00:16:41.714: ISDN BR1/0 Q931: TX -> DISCONNECT pd = 8
> callref = 0x0031
> Cause i = 0x8290 - Normal call clearing
> *Mar 4 00:16:42.226: ISDN BR1/0 Q931: RX <- RELEASE pd = 8 callref =
> 0x8031
> Cause i = 0x8190 - Normal call clearing
> *Mar 4 00:16:42.230: ISDN BR1/0 Q931: TX -> RELEASE_COMP pd = 8
> callref = 0x0031
>
>
> I know it has something to do with the progress indicator (there is
> none in the first call) but do i have to fix it on the gateway or it
> has somenthing to do with the PBX?
>
> Thanks
>
> Anthony
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060119/a6c3e8d1/attachment.html
More information about the cisco-voip
mailing list