[cisco-voip] my digits are being cut off going out the gw

Sat Jul 15 09:52:39 EDT 2006

Have you tried the Dialed Number Analyzer?  Sometimes it can help find a
problem like that....
https://CMIPADDRESS/dna is where you access it...

Steve Brickhouse

On 7/15/06, Erick Bergquist <erickbe at yahoo.com> wrote:
>
>   Try setting the gateway settings for called party plan/type to both
> Unknown. This depends on your carrier, but from my experiences unknown for
> both the called party settings works pretty much everywhere without
> problems. YMMV however.
>
> Also, your calling party number is only 4 digits. Again, YMMV.... some
> carriers don't like invalid calling party #s and will reject call so you may
> want to make the calling party # a valid number on the public network. I
> also find that setting calling party type/plan to ISDN and National works
> fairly well if it is in US but different carriers/setups may need other
> settings.
>
>  ----- Original Message ----
> From: "Voll, Scott" <Scott.Voll at wesd.org>
> To: jgrace at digitel.net; rratliff at cisco.com
> Cc: cisco-voip at puck.nether.net
> Sent: Friday, July 14, 2006 5:01:19 PM
> Subject: Re: [cisco-voip] my digits are being cut off going out the gw
>
> Could it be that it needs to go out the gw as international rather then
> national?
>
> Scott
>
> --------------------------
> Sent from my BlackBerry Wireless Handheld
>
>
> -----Original Message-----
> From: cisco-voip-bounces at puck.nether.net <
> cisco-voip-bounces at puck.nether.net>
> To: 'Ryan Ratliff' <rratliff at cisco.com>
> CC: cisco-voip at puck.nether.net <cisco-voip at puck.nether.net>
> Sent: Fri Jul 14 14:02:36 2006
> Subject: Re: [cisco-voip] my digits are being cut off going out the gw
>
> Right
> So when I look in call manager,  my route pattern is 9.011!  discard
> predot
> and that it.  Nothing is set on the route list/ group.   Now on cm gw
> config
> I have
>
> Outbound calls
> Calling line = default
> Calling party sel = originator
> Called party ie num = cisco
> Calling party ie number = cisco
> Called number plan = isdn
> Calling number plan = isdn
> Number of digits to strip = 0
>
> -----Original Message-----
> From: Ryan Ratliff [mailto:rratliff at cisco.com <rratliff at cisco.com>]
> Sent: Friday, July 14, 2006 4:50 PM
> To: James Grace
> Cc: cisco-voip at puck.nether.net
> Subject: Re: [cisco-voip] my digits are being cut off going out the gw
>
> You need to look in CM not at the gateway.  The gateway only sends
> what CM tells it to.
>
> -Ryan
>
> On Jul 14, 2006, at 4:46 PM, James Grace wrote:
>
> For some reason we are trying to dial 011 420 737 731130 and we get a
> message you have not dial enogh digits.  We dial this number from
> another phone system and it works just fine.  In the debug the called
> party number is getting cut off.  What could be causing this
>
>
>
> The number they are trying to dial is: 011 420 737 731130     Here
> are the
>
> debugs when I had them make a test call:
>
>
>
> Jul 14 18:33:08.238: ISDN Se0/0/0:23 Q931: TX -> SETUP pd = 8
> callref = 0x0FFA
>
>
>
>         Bearer Capability i = 0x8090A2
>
>                 Standard = CCITT
>
>                 Transfer Capability = Speech
>
>                 Transfer Mode = Circuit
>
>                 Transfer Rate = 64 kbit/s
>
>         Channel ID i = 0xA98383
>
>                 Exclusive, Channel 3
>
>         Display i = 'Emerson'
>
>         Calling Party Number i = 0x0181, '8906'
>
>                 Plan:ISDN, Type:Unknown
>
>         Called Party Number i = 0xA1, '0114207377311'
>
>                 Plan:ISDN, Type:National
>
> Jul 14 18:33:08.282: ISDN Se0/0/0:23 Q931: RX <- CALL_PROC pd = 8
> callref = 0x FFA
>
>         Channel ID i = 0xA98383
>
>                 Exclusive, Channel 3
>
> Jul 14 18:33:08.574: ISDN Se0/0/0:23 Q931: RX <- PROGRESS pd = 8
> callref =
>
> 0x8
>
> FA
>
>         Progress Ind i = 0x8A81 - Call not end-to-end ISDN, may have
> in-band inf
>
>
>
> Jul 14 18:33:12.862: ISDN Se0/0/1:23 Q931: RX <- CONNECT pd = 8
> callref = 0x90 D Jul 14 18:33:12.870: ISDN Se0/0/1:23 Q931: TX ->
> CONNECT_ACK pd = 8  callref = x100D Jul 14 18:33:17.286: ISDN
> Se0/0/0:23 Q931: TX -> DISCONNECT pd = 8  callref = 0 0FFA
>
>         Cause i = 0x8090 - Normal call clearing Jul 14 18:33:17.310:
> ISDN Se0/0/0:23 Q931: RX <- RELEASE pd = 8  callref = 0x8F A Jul 14
> 18:33:17.322: ISDN Se0/0/0:23 Q931: TX -> RELEASE_COMP pd = 8 callref
> = 0x0FFA Jul 14 18:33:36.658: ISDN Se0/0/0:23 Q931: RX <- DISCONNECT
> pd = 8  callref = 0 012E
>
>         Cause i = 0x8090 - Normal call clearing Jul 14 18:33:36.678:
> ISDN Se0/0/0:23 Q931: TX -> RELEASE pd = 8  callref =
>
> 0x81
>
> E
>
> Jul 14 18:33:36.706: ISDN Se0/0/0:23 Q931: RX <- RELEASE_COMP pd = 8
> callref = 0x012E Jul 14 18:33:44.642: ISDN Se0/0/1:23 Q931: TX ->
> DISCONNECT pd = 8  callref = 0 100C
>
>         Cause i = 0x8090 - Normal call clearing Jul 14 18:33:44.670:
> ISDN Se0/0/1:23 Q931: RX <- RELEASE pd = 8  callref = 0x90 C Jul 14
> 18:33:44.678: ISDN Se0/0/1:23 Q931: TX -> RELEASE_COMP pd = 8 callref
> = 0x100C Jul 14 18:33:46.162: ISDN Se0/0/1:23 Q931: TX -> SETUP pd =
> 8  callref = 0x100E
>
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
> ---
>
>
>
> ---
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20060715/585b341e/attachment-0001.html 