[cisco-voip] Credit Card Machine in a FXS port

[Carter, Bill]

It was reprogrammed.  I will hear today if everything is working.  They
were moving the fax line between the fax and CC machine and it worked
fine.  I think I had a cabling problem with the 66-Block punch down.

-----Original Message-----
From: Schmelkin, Richard [mailto:Richard_Schmelkin at adp.com] 
Sent: Monday, July 31, 2006 10:00 AM
To: Carter, Bill; Turpin, Mark; Patrick Mowry;
cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Credit Card Machine in a FXS port

Does your CC machine need to be reprogrammed to dial the outside line
access 
Code? Usually if the CC machine was on it's line to telco, it will need
to be reprogrammed to dial a 9 for an outside call if it did not before.

We run into that all the time. Just a thought. I might be off, but it
can happen.

Rich

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Carter, Bill
Sent: Monday, July 31, 2006 10:53 AM
To: Turpin, Mark; Patrick Mowry; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Credit Card Machine in a FXS port

I should find out if it is working to today.  I have a 2801 H.323
12.3(14)T7.  I am pretty sure this is a wiring problem.  The FAX line
works, they are able to swap the FAX and Credit Card lines.  I
re-punched on the 66-block.  I plugged in an analog phone and placed and
received calls.

voice-port 0/1/0
 disconnect-ack
 description FAX
 station-id number xxxxxxxxxx
 caller-id enable
!
voice-port 0/1/1
 description Credit Machine
 station-id number xxxxxxxxxx
 caller-id enable

dial-peer voice 452 pots
 description FAX
 destination-pattern 452
 fax rate disable
 port 0/1/0
!
dial-peer voice 838 pots
 description CreditCard Machine
 destination-pattern 838
 fax rate disable
 port 0/1/1
!
-----Original Message-----
From: Turpin, Mark [mailto:mark.turpin at bryancave.com] 
Sent: Friday, July 28, 2006 3:54 PM
To: Patrick Mowry; cisco-voip at puck.nether.net; Carter, Bill
Subject: RE: [cisco-voip] Credit Card Machine in a FXS port

I've used them before on a VG248.  The major problem was their digit
timing.  They were pulsing in digits about 20msec faster (or something
similar) than what the VG248 would recognize.  The vendor was called in,
reprogrammed the terminals, and everything was fine.

-mark

-----Original Message-----
From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Patrick Mowry
Sent: Friday, July 28, 2006 2:43 PM
To: cisco-voip at puck.nether.net; bcarter at sentinel.com
Subject: RE: [cisco-voip] Credit Card Machine in a FXS port

What type of gateway and signalling protocol?  It is not supported on
ATA devices, so I used a 2801.  My PRI lines are on an MGCP gateway, so
I setup the 2801 with MGCP as well.  I added:

mgcp modem passthrough voip mode nse

I don't know if it really was needed or not, but I added it in before
testing the telecheck machines and they worked fine.  The TeleCheck
machines validate checks and credit cards.  So if they worked for me,
they should work for you ;)

-Patrick

----------------------------------------------------------------------
	From: Carter, Bill [mailto:bcarter at sentinel.com] 
	Sent: Monday, July 24, 2006 3:16 PM
	To: cisco-voip at puck.nether.net
	Subject: [cisco-voip] Credit Card Machine in a FXS port

	I am having some funny problems getting a credit card machine
working.  It is plugged into a FXS port on a voice gateway.  Is their
any special configuration parameters required? 
 
This electronic message is from a law firm. It may contain confidential
or privileged information. If you received this transmission in error,
please reply to the sender to advise of the error and delete this
transmission and any attachments.
 
IRS Circular 230 Disclosure: To ensure compliance with requirements
imposed by the IRS, we inform you that any U.S. federal tax advice
contained in this communication (including any attachments) is not
intended or written to be used, and cannot be used, for the purpose of
(i) avoiding penalties under the Internal Revenue Code or (ii)
promoting, marketing, or recommending to another party any transaction
or matter addressed herein.

_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip


This message and any attachments are intended only for the use of the
addressee and may contain information that is privileged and
confidential. If the reader of the message is not the intended recipient
or an authorized representative of the intended recipient, you are
hereby notified that any dissemination of this communication is strictly
prohibited. If you have received this communication in error, please
notify us immediately by e-mail and delete the message and any
attachments from your system.


This email may contain proprietary and confidential information for the sole use of the intended recipient. 
Any review, retransmission, dissemination, or other use of this information by persons or entities other than 
the intended recipient is prohibited. If you are not the intended recipient, please contact the sender and 
delete all copies. To the extent that opinions are expressed in this message, they are not necessarily the 
opinions of Sentinel Technologies or any of its affiliates, employees, directors, officers or shareholders.