[cisco-voip] Break Mirror on HP MCS

[Klaczko, Edwin]

Thanks for the info, it was very helpful.

 

 

 

Eddie Klaczko

IP Telephony / Network Specialist

CC Schaumburg School District 54

eklaczko at sd54.org

  _____  

From: Voll, Scott [mailto:Scott.Voll at wesd.org] 
Sent: Friday, November 03, 2006 2:46 PM
To: Klaczko, Edwin; cisco-voip at puck.nether.net
Subject: RE: [cisco-voip] Break Mirror on HP MCS

 

Slot 0 is the drive to remove. And no the replacement drive does not
need to be blank.  I only have a couple extra drives so I just reuse
them over and over again with out issue.

 

Scott

 

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Klaczko, Edwin
Sent: Friday, November 03, 2006 9:13 AM
To: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Break Mirror on HP MCS

 

Sounds like a little of each.  Thanks to everyone for their input it was
helpful.  I have another question.  For RAID 1 does it matter which slot
I put the spare drive into?  Ex.  I pull a drive from slot 1 and keep as
emergency backup.  Insert a spare and have it rebuild (does it need to
be blank or can it have old data?).  Perform upgrade and system has
problems so I want to go back.  If I pull both drives out and insert the
emergency backup into slot 0 and powerup the server this is no problem
correct?  Or do I need to put the emergency into slot 1 power up and
then insert another into slot 0 to rebuild the mirror.  I think there
are a couple questions in there somewhere.

 

 

 

Eddie Klaczko

IP Telephony / Network Specialist

CC Schaumburg School District 54

eklaczko at sd54.org

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Keith Klevenski
Sent: Friday, November 03, 2006 10:13 AM
To: Jason Aarons (US); cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Break Mirror on HP MCS

 

I've always just pulled the drive and put in a spare and let it rebuild
on our ancient 7835's.  good info here tho.

 

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Jason Aarons
(US)
Sent: Friday, November 03, 2006 10:03 AM
To: cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Break Mirror on HP MCS

 

You can't pull a SATA drive in a MCS-7825 hot, but I've pulled many SCSI
drives from DL-380s hot. The Event Viewer logs do a great job of showing
what's happening with the SCSI controller and the raid re-builds.  A
36GB drive takes almost exactly 45 minutes to re-build, it's all done in
Compaq hardware versus software.  Sure if you could power it off that
would be recommend, but I've seen a few sites with single MCS-7835 and
had to break the raid mirror couple days before a upgrade and powering
down wasn't a option.

 

Would you pull a 6724 or NAM or IDS module in/out of a 6509 hot?  Some
would say sure, others have lost switches on "hot-swappable" parts!

 

I know the IBM x440s we had you could replace CPUs and RAM hot in
production, only thing you couldn't swap hot was the motherboard!
24x7x365 non-stop computing!

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Voll, Scott
Sent: Friday, November 03, 2006 10:48 AM
To: Klaczko, Edwin; cisco-voip at puck.nether.net
Subject: Re: [cisco-voip] Break Mirror on HP MCS

 

I always shut down the Server.... Pull the drive.... Power up the
server.... Then put in the new drive.

 

I have never pulled a drive in use.  Probably not the best option.

 

Scott

 

  _____  

From: cisco-voip-bounces at puck.nether.net
[mailto:cisco-voip-bounces at puck.nether.net] On Behalf Of Klaczko, Edwin
Sent: Friday, November 03, 2006 6:17 AM
To: cisco-voip at puck.nether.net
Subject: [cisco-voip] Break Mirror on HP MCS

 

I've ordered some spare HDs and wanted to use them to keep an extra
backup.  I'm used to working with Dell servers and had a bad experience
pulling a hot-swap drive live.  Their RAID controller allows you to
power down a drive to remove it.  I couldn't find a similar feature on
the HP interface.  Is this necessary or is it safe just to pull the
drive live.  Any help would be appreciated.

 

 

Eddie Klaczko

IP Telephony / Network Specialist

CC Schaumburg School District 54

eklaczko at sd54.org

 

  _____  

Disclaimer: This e-mail communication and any attachments may contain
confidential and privileged information and is for use by the designated
addressee(s) named above only. If you are not the intended addressee,
you are hereby notified that you have received this communication in
error and that any use or reproduction of this email or its contents is
strictly prohibited and may be unlawful. If you have received this
communication in error, please notify us immediately by replying to this
message and deleting it from your computer. Thank you. 

-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20061103/df4e32e2/attachment-0001.html