[cisco-voip] 6608 MTP transcoder codec change

[Erick Bergquist]

Ok. Well, It fixed the issue I had elsewhere with a MGCP GW and G729 VAD type symptons.  

How would you do for MGCP if that parameter is for H.323 -- silence suppression service parameter?  I am trying to get calls on another MGCP GW that use a transcoder (6608 MTP) to use g729r8 instead of g729br8. 

That param text is a little old to, because it also states to set it to true on all nodes in the cluster, but it is a cluster wide parameter now.

Thanks, Erick

----- Original Message ----
From: Wes Sisk <wsisk at cisco.com>
To: Erick Bergquist <erickbe at yahoo.com>
Cc: ciscovoip <cisco-voip at puck.nether.net>
Sent: Tuesday, November 14, 2006 7:26:20 AM
Subject: Re: [cisco-voip] 6608 MTP transcoder codec change

That param was only supposed to affect the caps advertised over h323  
TerminalCapabilitiesSet.

/Wes

On Nov 13, 2006, at 4:57 PM, Erick Bergquist wrote:

Quick question....  when you set the CCM service parameter to strip G. 
729 annex B bit (silence suppression) to true do you need to reset  
MTP transcoder, MGCP gateway for them to take the codec changes?






_______________________________________________
cisco-voip mailing list
cisco-voip at puck.nether.net
https://puck.nether.net/mailman/listinfo/cisco-voip