[cisco-voip] Best Hardware for Voice Gateways for CallManager 4.2?

[Ed Leatherman]

For a VG200 size I would look at the 2800 series ISR routers. I've put a few
of them in and they've worked out just fine so far.

For high end they have the CMM module blades for the 6500's, they can do
T1/E1 or FXS I think. There's also the 6608 T1 blades (we currently use and
are happy with) - but they may be EoS at this point not sure. Either case
though you have to buy a 6500 chassis and a sup card.

On 11/17/06, Geisler, Kurt <Kurt.Geisler at haynesboone.com> wrote:
>
>  We have noticed that the 7200 VXR is no longer supported as an MGCP
> gateway in CallManager 4.2. We used to like the VG200 as gateways, and
> they are still supported in 4.2, they are just End of Lifed from Cisco.
>
> So, no low end VG200 and no high end 7200 for gateways. What would be a
> good platform for voice gateways to be used as local PSTN and voice WAN?
>
> I currently have 7206 VXR's everywhere and was going to use these as
> gateways for our VoIP solution, but now it looks like I will have to
> purchase additional hardware (maintenance, etc) just to have supported voice
> gateways.
>
> CONFIDENTIALITY NOTICE
>
> This electronic mail transmission is confidential, may be privileged and
> should be read or retained only by the intended recipient. If you have
> received this transmission in error, please immediately notify the sender
> and delete it from your system.
>
>
>
> _______________________________________________
> cisco-voip mailing list
> cisco-voip at puck.nether.net
> https://puck.nether.net/mailman/listinfo/cisco-voip
>
>
>


-- 
Ed Leatherman
Senior Voice Engineer
West Virginia University
Telecommunications and Network Operations
-------------- next part --------------
An HTML attachment was scrubbed...
URL: https://puck.nether.net/pipermail/cisco-voip/attachments/20061117/4c16625b/attachment.html