[cisco-voip] anyone used the newer linksys switches?

[Curt Shaffer]

I was handed a Linksys SWR208P to be tested for use on our network. I am
going through the DSCP settings for QoS for voice and it is quite
rudimentary. It appears that I need a MAC or IP ACL to associate to the DSCP
marking. Problem is that the ACLs here don't accept port ranges. Is this
suggesting that I need to add an ACL for every possible RTP port? That would
be ridiculous! Has anyone out there used these? If so can you share some
insight as to how you have your DSCP setup on it for voice?

Thanks

Curt